Want this question answered?
The exhaust manifold needs to have a gasket in place to help seal the juncture between the manifold and the engine. After the gasket and gasket sealer are in place, tighten the bolts for the exhaust manifold. The exhaust pipe can then be replaced on the new exhaust manifold.
Cylinder Head bolts 65 ft/lbs=Intake Manifold bolts 30 ft/lbs==Exhaust Manifold bolts 25 ft/lbs=
remove the intake and exhaust manifolds. there are bolts that attach them onto the head and there are bolts near the carburetor that attach the intake manifold to the exhaust manifold.
You will need to remove the exhaust manifold retaining bolts in your 1993 Chevy Astro. Remove the exhaust manifold. Remove the exhaust manifold gasket and clean the surface. Reverse the process to install the new exhaust manifold gasket.
I D K
What engine???????? You should refer to repair manual if not familiar with auto repair and understand the terminology before attempting Remove nuts holding exhaust manifold to cylinder head & remove nuts/bolts holding exhaust manifold to exhaust pipes Use new exhaust manifold gaskets and install the new manifold securing the manifold to cylinder head (may need to but new nuts and or bolts) by "snugly" tightening manifold to cylinder head if not refering to repair manual
The 1995 Honda Odyssey exhaust manifold bolt torque specification is 45 pounds. The exhaust manifold bolts should be torqued in 15 pound intervals.
24 ft lbs lower intake 115 inch lbs exhaust
Its a bit of a job because it is held on by the same bolts as the intake manifold, and the easiest way is to remove them both, otherwise the rusted exhaust bolts holding the tubing to the manifold is the worst.
Yes, they share the same gasket and bolts.
45 ft.lbs.
Exhaust mainfold to cylinder head 22 ft-lbsExhaust manifold to header pipe 33 ft-lbsExhaust manifold bracket bolts 20 ft-lbs