Any vehicle with McPerhson struts will only have 2 ball joints - lower.
The strut takes the place of the upper control arm/ball joint of the old days.
See "Related Questions" below for more
Two ball joints - one on each side.Until the advent of McPherson struts, there used to be upper and lower ball joints. The struts eliminate the uppers, so now there is only the lower.Note: ball joints on a 1996-1999 Taurus/Sable are a real bear of a job!See "Related Questions" below for more
Factory ball joints do not have a grease fitting. If yours have been replaced, it is then possible it will have a fitting.
how do you replace ball joints on a 2000 envoy
There is not a good and clear indication on how many ball joints are on a 2000 Ford Mustang. After searching around, there are conclusions that there are at least two ball joints on the Mustang.
Check the front wheel ball joints. Even more likely is the wheels/tires are out of balance.
The ball joints are bolt on parts that don't require any special tools to replace.
On a 2000 Lincoln LS : The FRONT suspension is a strut type suspension , so there are ( NO ) upper ball joints
how much would it cost on a 2004 mercury sable
Two. One on each side in the front. There are only lower ball joints on this vehicle. There are no upper ball joints - there are struts instead.
Check tie rods, ball joints, trac bar, and u-joints.Check tie rods, ball joints, trac bar, and u-joints.
I think 2000-2002 are welded in.
You need to have a "Ball joint press".