most likely 2, look underneath
I changed the blade belt on my Murray mower. Now one blade stops and goes. If I lower the deck the blade stop . What did I do wrong?
2 21inch blades.
That depends on what state you are in. I'm in FL and have a 42" for sale
I have Murray 42" cut riding mower that the belt came off. How do I put the belt back on?
Normally you will start to hear a loud grumbling sound from underneath the mower when the blades are engaged. With the mower shut off, release the tension from the belt for the blades. Raise the deck so you can grab the blades from the bottom. You should not be able to rock the blades from side to side or up and down. If you can then you probably have a bad spindle. You can do this for wach of the spindles to check them all.
There is a yellow wire under the seat on my 14.5 HP Murray 42'' deck mower, and plug it in or don't that's where all killswitches are on a Murray lawnmower and pretty sure they still are today.
Look under the seat. There should be an info plate.
Have not seen picture of belt for troybilt riding mower(deck ) my problem is when I disengage blades,it does not have enough slack and blades keep turning
first three things to check are: 1. low tire pressure 2. make sure both blades(if 2 blades) are in good shape. 3. look at deck. wheels ok. deck level. there are adjustments for deck.\ hope this helps.
I'd say $50,000$
Usually there is a problem with the belts that drive the blades, after you stop the mower. Take a close look at the belts and assure that the belt is tracking and the pulleys are aligned. If you are unsure of the belt routing recheck the manual.
Raise the machine up so you can safely work under the deck. I use a piece of 2" by 4" aprox 6" long and use it to jam a blade so that it won't turn while you remove the center bolt from the blade you have jammed with the piece of wood. Install the blades in the same manner.