0
There are too many variable, to really answer that question with any certainty, however, you muist be asking for a reason, so, I will try to give you a ball park, however, this is my disclaimer. 4 bolt main motors, truck, vs. car, pre smog, smog, ect. Too many variables. Either 10, or 16 main cap bolts, 5 flywheel bolts. Rod bolts, 2 per piston, so 16. 1 holds the oil pump in place, and I think 16 bolts hold the oil pan on. Timing cover has 10, maybe, and 4 at the fuel pump. Cam timing gear has 3, 1 down the center of the harmonic balancer, and 3 to hold the bottom pulley on. 4 for the water pump to block match-up, and another 4 to hold on the fan. 2, for the earlier alternator, and 3 more for the Power Steering. 13 head bolts, per side, and 4 more, per side for the valve covers. 16 nuts for the rocker arms, and 1 to hold down the distributer. 4 to bolt on the carburator, and 12, to seal up the intake manifold. 12 to bolt on the exhaust manifolds, or headders. Where are we now? About 175? I would say, then, on average, about 200......chuck
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What gasket is needed for the part that bolts to the block for the oil filter on a 350 Chevy motor?
no gasket is used
Where are the battery cables connected to a 1997 Chevy van motor?
The positive cable goes to the starter. The negative cable bolts to the engine block.
Where do you find the Motor number on a 350 Chevy small block 1969?
It will be on the right side of the block where the head bolts on. with right head on engine the block will stick out a little bit in the front the # will be right there. may have to clean or sand block to read.
How many head bolts do you have too remove on a 5.7 Chevy motor?
i just removed the heads in my 70' Chevy Monte Carlo. its a small block so i had to remove 17 head bolts. big blocks however are differrent. so it depends on the size engine you have.
Where is the starter on the Chevy 2000 Chevy Blazer?
The starter motor/solenoid on a 2000 Chevy S10 Blazer is on the lower passenger side of the engine block. If your trying to replace it, first, disconnect the negative battery terminal. Remove the differential carrier shield. Disconnect the bolted solenoid cables. Remove 2 vertical bolts securing the starter motor to the engine block. When reinstalling starter, tighten mounting bolts to 50 Nm/37 lb. ft.
Is a 400 small block a Chevy motor?
Yes.
Where is the starter located on a 1999 Chevy s-10?
On the passenger side of the engine where the transmission bolts to the engine block. Or you can disconnect the positive battery cable and trace it down to the starter. You can disconnect the large cable and the small wire from the ignition switch, the motor is held on by 2 bolts going up from the bottom, there may be shims between the motor and engine block.
Are the motor mounts the same for a big block and small block Chevy in 1970?
NO. Not even close.
What size motor has block casting numbers 14093638?
chevy 350
What is the crank rotation on a big block Chevy?
From the front of the motor, clockwise.
What is a 6.0 Chevy consider to be. Is it a big block or small block?
A small block. It is the first motor squared, by Chevy, meaning it has a 4 inch bore, and 4 inch stroke.
Where is the oil sending unit located on a 1989 Chevy Camaro RS with a 305 engine?
I believe it is located right above the oil filter. It screws into the motor block and will have 3 wires attached to it with a plug.
