0
How many foot pounds tight should my idler pully be on a 99 ford ranger?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace an idler pulley on a 1999 Ford f150 4.2ltr?
first you should release the belt tension pully and remove the belt. Then the idler pully has a bolt through the center remove the bolt and the pully should come off.
What is an idler on a Honda?
Most technicians refer to the idler pully for the timing belt as just idler.
How do you remove the fan unit on a peugeot 406?
Pin the top tension idler pully..take the front wheel off...the bottom idler pully is on an excentric...loosen same....belt goes slack.... put new belt on,set the excentric as tight as possible.. remove the pin in the top tension idler pully belt should be tight after doing this... happy days
Why does serpentine belt keep shreadding on 1999 ZX2 quickly in less than 1 mile?
you have a bad bearing on either the tensioner pully or the idler pully. both should be replaced for success.
Replacing an idler pulley on a 93 Jeep Cherokee sport?
Unbolt, slide off. Slide on new part, bolt back on.
Is the idler pulley for the 1991 Jeep Comanche truck the bottom pulley?
the idler pully is the top center that that spins freely and is connected to the block.
What is an idler pully?
An idler pulley is a pulley that does not drive and is not connected to any device that is driven. It serves to either tension a belt or to route a belt to clear an obstacle.
What pully do you loosen to change the belt on a 96 sunfire?
idler pulley, the only one that will move
How do you change the serpentine belt on a 1995 olds aurora?
Find the idler pully of the serpentine belt system. It is usually the one that appears to not "drive" any system and is normally located towards the top of the other pullys. On the idler pully assembly, you will find a bolt (not the bolt in center of pully or the one at the pivot point of assembly). Using the correct sized socket and a large ratchet (or wrench) as a lever, pull or push the idler pully assembly, which is spring tensioned, until the pully moves in far enough to get new belt on. Slowly release tension until belt is tight against the idler pully under the assembly's spring tension. Be sure belt is properly seated on all pullys without any twists.
The front idler pully on your 1999 vr5 engine has sheared offIs it recommended to replace all the pulleys and water pump?
The water pump and timing components should be replaced at intervals specified by manufacturer and you may replace just the idler pulley.
What is the correct name for the lower serpentine belt tensioner on a 1996 dodge avenger 2.5es?
Idler pully.
How do I ID the specific name of the pulleys for the belt on the engine. it is not the tensioner with it's connected pulley. The pully is located in the center at the top and appears smooth?
It is called an Idler pully and is not there to tension the belt.
