0
How many hours to put in a distributor in a 4.3 s-10 2002?
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you put distributor in 2002 blazer 4.3?
how to install a distributor
How many hours do you have to put in as a pediatrician?
I dont really know but i think you have to put at lest 40 hours
How many volts does a distributor put out?
The older traditional points-distributor systems of the late-60's early-70's could put out around 40,000 volts, but the later electronic ignitions can go as high or higher than 60,000 volts.
How do you put an alternator on a 2002 Chevy?
There were many different "Chevy" models in 2002. State the model to get a decent answer.
You put a 305 in your camaro it has a carb do you have to change the distributor to a hei?
No, you don't have to change to the new distributor if you don't want to.
How many lbs of ac to put in 2002 Malibu?
1.4-lbs
How to Adjust timing 97 Jeep 6-cylinder?
Distributor timing is adjusted by rotating the distributor. A scan tool is required to put the engine computer in distributor sync mode. The distributor is then set to zero degrees.
How many animals get put down in 9 hours?
23
How do you remove the distributor on a 4 cylinder Chevrolet Celebrity?
To remove the distributor on your Chevy Celebrity 2.5L 4 cylinder engine: 1, Set the timing to the number one cylinder in the firing position. 2. Remove the distributor cap and put out of the way. If you take out any of the spark plug wires make note of where to put them back. 3. Loosen and remove the retainer clamp and its bolt. 4. Pull the distributor out of the block. To reinstall the distributor reverse the instructions. You will need to re-time the engine when you put the distributor back in.
Will a distributor off of a 1991 Honda Civic fit a 1992 Honda Civic?
Why do you want to put an OBD0 distributor in a OBD1 motor?
Does a 77 350 have point?
Not unless someone put a breaker point's distributor in it. It had an HEI / HIGH ENERGY IGNITION distributor in it from the factory.
What happens if you put the distributor cap the wrong way around?
Could damasge the distributor/hall sender leading to a starting fault.
