Don't know off-hand, but these guys will. http://forums.vwvortex.com/zeroforum?id=27
The torque specs for a Toyota Camry cylinder head is 60 pounds for the inside bolts and 50 pounds for the site bolts. The cylinder head bolts should be tight from and to end alternating.
The torque specs for a Cadillac depend on which engine it has. For most 425, 572, 368, and 500 engines, the torque for the head bolts is 115 ft. pounds. The torque for the cam bolts is 25 ft. pounds, and the torque for the valve covers is 10 ft. pounds.
There are either eight or ten bolts on the head of Jinma tractor. The torque bolts require 95 to 105 foot pounds.
65 foot pounds for re-used head bolts and 72 foot pounds for new head bolts.
The cylinder head bolt torque specification is 90 pounds. The cylinder head bolts should be torqued in 30 pound intervals.
65 foot pounds.
The cylinder head on a Toyota Paseo requires 33 pounds of torque on the head bolts. If the bolts are over tighten the block can warp leading to a blown head gasket.
The 3800 Pontiac engine had bolt torque specification is 160 pounds. The head bolts should be torqued in 40 pound intervals.
20 foot pounds
Torque the head bolt on a 1993 Toyoto 22RE three times at 58 foot pounds of torque. The 22RE head bolts are not torque-to-yield (stretch), and are re-usable. Torque is 55-63 foot pounds. Thoroughly clean the bolts on a wire wheel and inspect for pitting, especially in the threads and replace as necessary. It is also recommended to re-torque them after about 1,000 miles. ChaCha!
100 inch/pounds
The 2002 Cavalier 2.2 liter engine cylinder head bolt torque specification is 120 pounds. The cylinder head bolts should be torqued in 40 pound intervals.