1990 FORD BRONCO II 2.9L 6-cyl Engine
CAPACITIES
Engine, without filter..........4.0 quarts [1]
Wix Oil Filter.........51515
Cooling System, W/O AC Initial Fill..........7.4 quarts
Cooling System, with AC Initial Fill..........8.0 quarts
Automatic Transmission, Initial Fill..........3.0 quarts [2]
Automatic Transmission, Total Fill
2wd ..........9.0 quarts
4wd ..........10.0 quarts
Manual Transmission, 5-SPD Mazda..........5.5 pints [3]
Manual Transmission, 5-SPD Mit..........4.9 pints
Differential, Rear..........5.1 pints [4]
Differential, Dana 28 Front..........1.1 pints [5]
Differential, Dana 35 Front..........3.6 pints
Transfer Case,Warner 1354..........2.5 pints
Transfer Case,Warner 1350..........3.0 pints
1. When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase.
2. With ENG at operating temperature, shift through all gears. Check fluid level in PARK and add fluid as needed.
3. Mazda TRANS has drain plug is on the driver's side of the case. Mit drain plug is at the center of the pan.
4. Fill to no more than 1/4 to 9/16" below fill plug hole.
5. With Dana 28: If fill hole is at centerline of axle must have lube level no higher than 1/2" below fill hole. Models with fill plug below centerline of axle must have lube level no higher than 1/8" below fill hole.
Hope This Helps.
5 quarts + filter
The engine choices in the full size Ford Bronco for 1990 were the 4.9 liter straight six cylinder , or the 5.0 liter V8 , or the 5.8 liter V8 engines
6 quarts
According to one of Fords websites : For a 1990 Ford Bronco II , 2.9 liter V6 engine : The spark plugs are gapped at ( .044 inch )
No , the 2.9 liter V6 engine in a 4X4 , 1990 Ford Bronco II is fuel injected
According to one of Fords websites : For a 1990 Ford Bronco 5.8 liter ( 351 cubic inch ) V8 engine : The spark plugs are gapped at ( .044 inch )
I own A 1994 Ford Bronco Eddie Bauer with a 5.0 liter engine. The answer to your question is the oil capacity is exactly 6 quarts for an oil change.
According to the 1996 Ford Bronco Owner Guide : With engine oil filter change : ( 6.0 U.S. quarts , 10W-30 is the PREFERRED oil for the 5.0 L in a 1996 Ford Bronco )
With engine oil filter change : The 2.8 liter V6 engine in a ( Ford Ranger ) holds ( 5 quarts )
The last model year for the full size Ford Bronco was 1996 . The Ford Bronco NEVER used the 4.6 liter V8 engine
yup.
The oil capacity for a Ford Bronco is approximately 5 quarts of oil. The recommended oil type is 10 W 30.