Before you remove outter tie rod you should make sure inner tie rod is secured (not able to turn). Then count the amount of turns it takes to remove outter tie rod. Install new part with the same amount of turns it took to remove old part. You will always need an alignment after replacing front end parts.
If you did not count turns during removal, ensure steering wheel is straight and adjust tie rod (how far you install it) until wheel appears to be pointed straight. Then get an alignment.
Check battery cables/connections.
did you try turning it backwards or left handed. I had a Nissan Maxima and the pistons were left handed
Not sure if it's the same but on a J30 and Nissan Maxima you put the key in the truck luck and open it. That turns off the alarm.
Bad gas mileage. Car studders or shuts off at stop or turns. Black smoke.
i would replace fan relay, before replacing thermostat. the relay acts as a thermostat for the fan, turning fan on and off when needed
NO!! You must use spacers to move th rims out and raise and stiffen your suspension. Stiff shocks and spring spacers are the cheapest alternative for the ride height and you can get spacers at any rim shop.
Yes it turns on when you have low fuel.
i had the same problem your power stering pump is going
They claimed about 100mls but it turns out you will struggle to get 75mls out of it
If a Nissan Sentra stalls when making turns, check the fuel and spark. The coil may be cutting out when it gets hot.
I just had that same problem on my 02 Maxima SE. My radiator was shaking so hard, and my fan would vibrate so loud, that if you didn't look at my car, you'd think it was a motorcycle by the way it sounded. That was embarrassing. It sounded just awful! I bought a new radiator fan. It cost about $100 and $60 to service it. It works just fine now. It runs so quietly now! :oD
Worn out CV joints