answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How might you manipulate the size of the axle powering the input pulley or sprocket to harness more speed from the output?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Processor existing computer instructions that manipulate data results in useful output?

Process,or existing computer instructions that manipulate data, results in useful output?


Remove front chain sprocket on 1983 Honda ATV big red 3 wheeler?

Take off the chain and then there should be 2 little bolts holding on the sprocket. Remove those and then rotate the sprocket slightly so its teeth line up with the teeth on the output shaft and it will slide right off.


What are four functions of a computer?

1 : Input (Enter Data ) 2: Processing(Manipulate Data ) 3: Output ("View" Processed Data ) 4: Storage ( Store Data)


Does anyone have information on error 0722 and 0723 automatic transmission on a 2002 exploer XL transmission has been rebuilt but continue to get the errors even after resetting?

P0722 - No signal from Output Shaft Speed Sensor . The output shaft speed sensor failed to provide a signal to the PCM upon initial movement of the vehicle (damaged OSS connector / damaged OSS sensor , or not installed properly / Harness intermittently shorted or open ) P0723 - Output Shaft Speed Sensor circuit intermittent failure . The Output Shaft Speed Sensor signal to the PCM is irregular or interrupted ( Harness connector not properly seated / harness intermittently shorted , or open / harness connector damaged / OSS sensor damaged , or not installed properly - verify harness and connector integrity - verify OSS sensor proper installation )


Is 500 watts of AC power is being drawn on an inverter how many amps are being drawn on the batteries powering the inverter?

Inverter efficiencies vary about 50% when a small about of power is being used, to over 90% when the output is approaching the inverters rated output. Your question cannot be answered without knowing the inverters rated output.


Where is the output speed sensor on a 1999 Hyundai accent?

The output sensor is on the top of the transmission closest to the driver side. It connects in a harness that plugs into a connector toward the front of the car which then goes to the input sensor which is toward the bottom.


What is needed to play an aftermarket radio in a 95 Nissan 240 besides a radio harness mine had a factory clarion system in it with a built in amp?

The correct wiring harness should allow the radio to play. Make sure that the output of the radio is correctly wired to the amp (don't feed a high output speaker line into a low power amp input).


How do you make electric bike go faster?

Change the sprocket on the motor that spins the tires via the chain to a smaller size, that's a start. If it has a output plant purchase one with more voltage and add it on.


Where is Buick 3800 VSS sensor?

The VSS is located on the transmission bell housing, on the passenger side near the output of the drive shaft there will be a wiring harness plugged into it


How to Upgrade voltage on Lexus gs 300?

I'm assuming you have a million gadgets that need powering and your headlights flicker?? If so, consider a 2nd battery over the alternative of a higher output alternator. Do a search on Google and you'll see why.


Is there a difference between Laptop Power supply and Desktop power suppply?

Laptop power supply provides a much lower watt output compared to desktop because its powering a smaller and more energy efficient device. Do not try mixing them


What is welding generator?

A welding generator is an electricity generator that is commonly used in places where the power needed to arc weld is not readily available. They are usually powered by gas or diesel engines and have a high, stable energy output suitable for powering a welding machine.