Approx. $1,000 USD from a Saturn dealer. You may want to also change the water pump at the same time.
It will cost you $0.00, due to the fact that a Ford F-150 does not have a timing belt, it has a chain that requires no maintenance.
Simple answer is yes. The water pump is driven by the timing belt. P.S if you are not sure on how to do this job then pay a reputable workshop. You can bend cylinder head valves if you replace the timing belt incorrectly and then you are talking thousands to repair your car! Steve:-)
The water pump runs on the timing belt. You have to take the timing cover off, remove the belt and then remove the water pump. If you reuse the timing belt, mark the belt with a spot of paint at the camshaft and crankshaft so that you can replace it and have the engine in time. If you need to replace the belt, make sure the engine is at top dead center on the timing mark before you remove the belt.
If everything was fine before the new belt was fitted then the most obvious answer is that the timing belt has been fitted incorrectly and the timing is wrong.
On most engines, the water pump drive belt is also the timing belt.
2002 L-series used a belt.
The V6 uses a timing belt. The 4 cylinder uses a timing chain.
About $500 to $600 for the belt, and another $150 or so for the water pump.
this specific year came with a timing belt instead of a chain, even though it has the v6 engine, which surprised me as well
It should cost no more than $350, if u also replace the timing belt, which i recommend. The total w both water pump and timing belt should cost $375, and that's a padded estimate.
I believe you need to replace a timing belt. Cause it uses timing chain which doesn't required to change as timing belt.
every 90,000 miles average to replace timing belt
The "L" series Saturns came in two varieties; the 4 cylinder (which used a timing chain), and the V6 which used a timing belt. To replace the timing belt on the V6 you must use the specially designed tool to lock the camshafts and crankshaft in place while you replace the belt. To replace the timing chain on the 4 cylinder, you must remove the front housing. It's easier to just remove the engine.
It sounds like your "Timing Belt" broke. Have it checked, if it's broken it should cost around $200 to have it replaced on your six cylinder L300.
Before you replace timing gear or belt check codes with code reader, may be a crankshaft position sensor. Sensor is very easy repair and L300 isn't going anywhere if that sensor is malfunctioning.
how do i change timing chain on 95 saturnsc1 1.9 sohc
On the V6 L300 it is in the passenger side of the car directly below the motor mount. The bolts are behind the timing belt cover.