Want this question answered?
You can replace the front wheel bearing, on your Kawasaki Mule 3010, by removing the axle. With the axle Remove the wheel bearing will slide off.
You can remove the front brake drum, on your Kawasaki Mule 2500, by removing the wheel and axle. The brake drum will slide off.
It is on the front left side of the frame just below the front left axle shaft.
Can you show me pictures on a dodge neon 1998 on how to remove and replace a front axle.
36mm
Dana 60
36mm
150 ft lbs.
94 ft/lbs rear axle nut 94 ft/lbs front axle nut 14.5 ft/lbs front axle clamp bolts I've also seen 92ft/lbs for the axles, I would use the 92 since it's the lower number, but it's not off by much so there you go, enjoy
1 and 11/16 in
It keeps the front axle in the correct left to right alignment.
Securely support the bike, with the front wheel off the ground. Loosen the pinch bolt at the bottom of the fork. Remove the bolt, from the axle, holding the axle from turning by inserting a small screwdriver or rod through the hole in the other end of the axle. Remembering to account for the wheel dropping, slide the axle out, being careful to note the location and direction each of the spacers is installed.