i paid $200 retail should be about $250
Your local Lincoln dealer should Have it.
where is the speed sensor for lincoln navigator
To install a height sensor on a 1998 Lincoln navigator is easy. All you have to do is turn your wheels all the way on whichever side you wanting to it on place the part in and screw the four bolts on.
Check Owner's Manual. If you do not have one. Check Related links below.
Check Owner's Manual. If you do not have one. Check Related links below.
where is the compressor sensor for a 2005 Lincoln navigator
you have to have a special height sensor tool that can adjust it for you, go to the local parts store and see if they sell it, or if your lucky enough to have a friend that has one.
Speed Sensor The sensor is located on the rear axle housing.
On a Lincoln Navigator : Bank 2 is the drivers side of the engine * sensor 1 would be close to the engine BEFORE the exhaust enters the catalytic converter
On a 1998 Lincoln Navigator : Bank 1 is the passenger side of the engine Sensor 1 would be close to the engine BEFORE the exhaust enters the catalytic converter Sensor 2 would be AFTER the exhaust has passed through the catalytic converter * sensor 1 is used to send a signal to the Powertrain Control Module / PCM for it to adjust the air / fuel mixture for the engine * sensor 2 is also called a catalyst monitor
On a Lincoln Navigator : Bank 2 is the drivers side of the engine Sensor 1 is close to the engine and sends a signal to the Powertrain Control Module that it uses to adjust the fuel ratio Sensor 2 would be in the exhaust AFTER the exhaust passes through the catalytic converter ( downstream sensor , also called a catalyst monitor ) ---------------------------------------------------------------------------------------------- Bank 1 is the passenger side of the engine and also has sensors 1 and 2
On a 2000 Lincoln Navigator : Bank 2 is the drivers side of the engine Sensor 1 would be close to the engine before the exhaust enter the catalytic converter ( upstream sensor ) Sensor 2 ( downstream sensor ) would be in the exhaust after the exhaust exits the catalytic converter