Remove 2 screws holding cup holder, then remove cup holder. Remove 2 screws holding ashtray, then remove ashtray. Then slowly work the beazel out, will need to tilt steering wheel all the way down and unplu cig. lighter and power source once bezel is out far enough. Then the light switch is 2 or 3 screws. Really not bad. Should not take more than about 20-30min and that is working slow.
take it out then replace it
Check out the enclosed instruction book.
I couldn't replace just the bulb. You have to buy a whole new lamp. $5-10 at autozone.
you can't. You have to replace the whole headlight assembly, it doesn't come apart. check the junk yards or eBay it's cheaper.
If you're removing the headlight assembly,you'll need to remove the turn signal light lenses,then the grill. From there you will see four bolts to each headlight assembly. It's pretty straight forward from there.
Open the hood. On top of the headlight assemblies, there's a curved metal rod. Pull that out, and you can pull the headlight assembly right out. From there, you turn the bulb ballasts counterclockwise and pull them out, and you can either replace the bulbs at that point, or the whole headlight assembly if necessary.
If it was removed then YES.
the fuel pump is inside the gas tank, the tank has to be removed and the fuel pump can be removed from the top of the tank.
The 1984 Toyota pickup truck headlight relay switch can be found in the fuse box. The headlight relay switch will be at the top of the third column.
you need to unclip the front grill and unscrew the four screws on each head light and unplug and replace the sealed bulb. hardest part is unclipping the grill
The headlight relay on a 1989 Toyota pickup is located on the right side of the engine compartment. There is a fuse box on the right-hand side fender wall. The headlight relay is in this fuse box.
There is no access panel. The tank has to be removed to replace the pump.
how do you replace a CV joint on a 1992 Chevy pickup?
It may be more difficult to remove the bed than to drop the tank.
On My 93 pickup it , you have to remove the battey and its is just inside the fender. Rick
Follow the link this will help.
H13 (or 9008)
I think its on the firewall under the hood
replace 1987 dodge pickup/power window motor
Yes because you have to take the bolts out of the transmission and slide back enough to replace your clutch.
You replace the entire thing
how do you replace a turn signal flasher on a 1999 ford ranger pickup
Pop the hood you will see the cord running to it. It is a matter of turning it so it will pop out undo the clip but new one on. insert into hole turn it back to connect on and your done. See sources and related links below for replacement headlight bulb information.
The Chevrolet S 10 pickup truck idler arm can be removed by removing the idler arm retaining bolts. The idler arm has two retaining bolts. Reverse the process to install the new idler arm.
You can replace the rear Main seal on the oil pump of your Dodge ram 1505.9 L pickup truck by removing the camshaft bearing. Once the bearing is removed the seal can be removed with a seal puller. Reverse the process to install the new seal.