answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2008-12-14 23:32:41
2008-12-14 23:32:41

I paid $495.00 dollars

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


36mm. You will also need an 18 mm box wrench to replace the bearing assembly.


If all goes well the job should take about an hour with proper tools and equipment. Keep in mind that if the hub/bearing assembly is rusted in, it could take longer.


how to replace front wheel bearing on 1996 Hyundai elentra


You can replace the front bearing on 2003 Citroen Relay using air tools.


the library should have a shop manual for this vehicle :)


how do you replace seatbelt retractor on a 2000 chevy blazer


You can replace the front wheel bearing, on your Kawasaki Mule 3010, by removing the axle. With the axle Remove the wheel bearing will slide off.


you can replace it by taking it to the shop and they will do it for you.



To replace the front wheel bearing on a Ford Fiesta, you will need to remove the wheel. Then with a hammer you can pull the old bearing out.






The front hub and bearing assemblies are the same for left and right side.


Is the wheel bearing on the front or the rear ????.. There is a big difference ...


I have a leak on my drive shaft left front 2000 cheve Blazer I would like to replace the whole unit


A front popping on the left of a 98 Blazer could be the brakes, steering, or wheel bearing. Check all three to find the cause.


you need to press out the bearing inside the hub assembly.


The front wheel bearing is a sealed unit with the wheel hub - replace the hub and wheel bearing unit. Remove the four bolts from the rear of the steering knuckle that connect to the hub bearing unit.


How do you replace rear wheel hub and bearing.



To replace the front bearing,jack up front and remove the wheel.Remove the brake caliber assembly and pads.The brake caliber guide ,held in place by 2 bolts that is bolted to the hub assembly has to be removed in order to remove the rotor.Remove the 3 bolts which hold the wheel bearing to the hub assembly,from the backside.Remove the 35mm axle nut using an inpact drill or strong arm.Tap the axle out of the assembly and the bearing assembly should come out from the front.


www.trailvoy.com All the answers for your Trailblazer from true enthusiasts.


If it is the front bearing: Take it to a mechanic. The bearing in pressed into the spindle. A press is required to remove the old bearing and install the new one.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.