Typically, replacing an exhaust will cost between $200 - $300, or the regional equivalent. Replacing an exhaust for a Peugeot 206 should not cost more than $300. Customers should be wary of scams, as certain garages may overcharge for some services.
That large tag on the headlight bulb for the 206 should it fit to the top or the bottom when fitted
Depending on the year and the engine variant fitted, anywhere from 50K to 90K miles. Check with your local Peugeot garage the Reg. or VIN and they will tell you.
If you are running a standard exhaust system, the mixtures should be ok at one and a half turns....if not standard...go 2 turns on the mixture screws. Hope this helps you!
Get yourself fitted.
96000 miles I believe. Mine went at 77000 the car was nearly 9 years old but because I had a full service history Peugeot fitted a new engine foc and loaned me a car in the meanwhile. My advice would be to change it between 60000 &70000 miles for peace of mind.
You should be able to but you will need new mounts and some links.
"It would not have fitted" is the correct grammar.
Exhaust manifolds should be covered by warranties.
Yes the intake and exhaust valves have to be close.
A dry sauna does not need a exhaust fan
yes it should just have to change a few brackets and pipes
Sensor should be replaced with a new one if this sensor is faulty the engine will not start! the sensor as a sacrificial pin which is fitted up to the timing gear, the pin determines the working gap (1.2mm) and is removed on start up.
This website should answer your question. It lists a lot of Peugeots and yours should be there. Go to http://www.denso.com.au/sparkplug/make/10/peugeot . :)
contact the maker of the exhaust everyone should have a shop manual for their vehicle, and the library should have a professional shop manual(wiring diagrams and more detailed info) available in the reference section for FREE....make copies of the right sections, and fix it like a PRO!! good luck Dave :)
A 4-amp fuse.
You should try online store such as amazon.com, ebay.com or homescapesonline.com. I have browsed websites and found that here you can buy Egyptian Cotton Fitted Sheets easily.
there should be one on the exhaust manifold and there should be another one after the catylitic convertor on the exhaust pipe
The oxygen sensors that connect to the exhaust system. There should be two, and they should screw into the side of the exhaust.
It should say in your handbook.
You should find it on the lid of the fusebox.