0
How much time is required to remove and replace the intake gasket on a 98 Lumina 3.1?
Wiki User
∙ 17y ago
I did this job 2times 5 years ago, i did it in my driveway and it took a few evenings, took it for a drive and it was leeking oil all over so i took it to a friends house to do it again again it took 2 evenings, the leak was not the intake gasket but the O-ring on the oil pump drive (where the distributer should have been) hope this helps
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you replace 98 Chevy lumina intake gasket?
if you are going to replace the intake gasket you might as well change the head gaskets at the same time[it will cost you a little now but save you a lot later
What will cause coolant to get in oil head gasket or intake gasket?
The Intake gasket is leaking, NOT THE HEAD GASKET. Replace the intake gasket
How do you replace the intake gasket on a 1992 Chevy Lumina Z34?
I'll assume Lower Intake Gasket, since they tend to cause vacuum leaks. Get a manual from Autozone and expect about 4 hrs labor, you need to take off the upper intake manifold just to replace the Lower Intake Gasket. Probably should change/clean the PCV valve while ur in there. Good luck, man.
How do you change the intake manifold gasket in a 3100 Chevy lumina?
take it to a mechanic
How do you fix intake gasket on 2000 lasabre?
The only fix for a bad intake gasket is to remove the intake manifold and replace the gasket.
Can you use a sealer to fix the intake gasket leak?
NO. You MUST replace the intake gasket.
Do you have to replace the intake gasket when removing intake manifold?
Yes, you must install a new intake manifold gasket.
Intake manifold gasket leak?
Replace gasket why does gasket keep sliding
How do you replace the lower intake manifold gasket in a 99 Chevy Venture?
there is no lower intake gasket, only a front and rear gasket
Why is 1997 Chevy lumina leaking water behind motor?
i had this problem the intake manifol gasket is blowed
Where could engine coolant be leaking from on rear topside of engine on a 1998 350vortec it pours coolant out but can't see where from?
It is common for the intake manifold gasket to leak antifreeze from the corners of the intake. Need to replace intake gasket. Be sure to look closely at the intake were the gasket seals against it for pitts in the intake. There is a heater hose that goes into the intake on right rear corner in the back, but uo on top of intake. check closely. It is common for the intake manifold gasket to leak antifreeze from the corners of the intake. Need to replace intake gasket. Be sure to look closely at the intake were the gasket seals against it for pitts in the intake. There is a heater hose that goes into the intake on right rear corner in the back, but uo on top of intake. check closely. It is common for the intake manifold gasket to leak antifreeze from the corners of the intake. Need to replace intake gasket. Be sure to look closely at the intake were the gasket seals against it for pitts in the intake. There is a heater hose that goes into the intake on right rear corner in the back, but uo on top of intake. check closely. It is common for the intake manifold gasket to leak antifreeze from the corners of the intake. Need to replace intake gasket. Be sure to look closely at the intake were the gasket seals against it for pitts in the intake. There is a heater hose that goes into the intake on right rear corner in the back, but uo on top of intake. check closely. It is common for the intake manifold gasket to leak antifreeze from the corners of the intake. Need to replace intake gasket. Be sure to look closely at the intake were the gasket seals against it for pitts in the intake. There is a heater hose that goes into the intake on right rear corner in the back, but uo on top of intake. check closely.
2002 impala intake gasket repair?
Repairing intake gasket not preferred, you can use red silicone to seal it, but to do so, you must remove the intake, in which case, you may as well replace the gasket.
