0
How much tranny fluid does a 98 Ford Ranger standard 5 speed take?
Wiki User
∙ 11y ago
According to the 1998 Ford Ranger Owner Guide :
( 2.65 litres / 2.8 US. quarts of Motorcraft MERCON automatic transmission
fluid is used in the 5 speed manual transmission )
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What type fluid in a 97 5 speed manual tranny for a ranger?
Motorcraft MERCON automatic transmission fluid in the 5 speed manual transmission on a 1997 Ford Ranger , according to the Owner Guide
What is the transmission bolt torque for a 1994 Ford Ranger?
it is a manual 5 speed tranny.
Where do you check transmission level on a manual 5 speed ford explorer sport trac truck?
A manual tranny does not take tranny fluid. So you can't check it. A manual tranny does not take tranny fluid. So you can't check it.
Where is the speed sensor on a 2000 Ford Ranger on the tranny?
1998 and later models are not equipped with a Vehicle Speed Sensor (on the tranny). The PCM receives vehicle speed information from the antilock brake system rear wheel speed sensor. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups.
Will a 1990 5 speed tranny from a 2.9 ranger fit in a 1985 ranger with a 2.8 engine?
Yes, any 2.8 will fit in a transformer.
What would cause a 93 Ford Ranger 5 speed manual transmission to not move when in gear and stall out when you take your foot off the clutch while in neutral?
my guess would be theres no fluid in the tranny and it had been welded together. similar to what happened to mine when it ran out of fluid at 70 mph on the interstate. and yes, it was a 93 ford 5 speed ranger. remember to check fluids
How many qts of transmition fluid gors in a 91 Ford Ranger 5 speed tranny?
On a 1991 Ford Ranger , 5 speed manual transmission : -------------------------------------------------------------------------------------------------- If you have the Mitsubishi made 5 speed manual transmission ( code " D " ) it takes ( 2.4 U.S. quarts of 80-90W gear lube ) --------------------------------------------------------------------------------------------------- If you have the Mazda made 5 speed manual transmission ( code " M " ) it takes ( 2.8 U.S. quarts of MERCON automatic transmission fluid )
What kind of oil does a 2000 model Ford Ranger use in a standard transmission?
Motorcraft MERCON automatic transmission fluid is used in the 5 speed manual transmission of a 2000 Ford Ranger according to the Owner Guide
Where is the manual transmission dipstick located on a 1992 ford ranger?
The 1992 5-Speed DOES NOT have a dipstick. You have to remove a threaded plug on the drivers' side of the transmission to check the fluid level. Be careful, the Mazda 5-speed tranny is to be filled with Mercon ATF (automatic transmission fluid), not heavy gear lube. Fill with fluid until it begins to run out of the threaded plug hole.
How much oil is standard in 2004 ranger?
According to the 2004 Ford Ranger Owner Guide : *** if you mean the standard ( or 5 speed manual transmission ) That takes approximately 2.65 litres / 2.8 U.S. quarts of Motorcraft MERCON automatic transmission fluid with the vehicle on a level surface
How do you change the tranny fluid in a 1996 ranger 4cylinder 5-speed?
There are two plugs on the side of the transmission. Remove the lower plug to drain and refill in the upper plug. Also, this transmission uses automatic transmission fluid (ATF) not the heavy 90W oil that older models used.
How do you check transmission fluid on a Chevy S10 5 speed manual tranny?
There is a plug on the side of the tranny. take it out. If fluid runs out, put the plug back in the hole and get on with life. If no fluid runs out, check your manual for what transmission fluid to use. Fill it till it runs out at the plug a bit. Be sure to use the transmission fluid recommended for Chevy S10 5 speed manual transmissions.
