BETWEEN $400 and $600
The water pump is located in front of the engine behind the timing belt cover. You need to remove the timing belt in order to get to the water pump, i suggests to replace the timing belt as well. This is a difficult job unless if you have done a timing belt replacement before.
The water pump is located behind the timing belt cover and is driven by the timing belt. You need to reove it to gain access to the water pump.
timing marks on 2002 Mazda millennium 2.5 dohc
with tools
100,000 miles
Replace the belt every 60,000 miles. Warning: This is an interference engine.
In order to remove the water pump on a 2000 Mazda Millennia, you must first remove the timing belt and the pulley for the water pump. Remove the pump itself by detaching the four bolts that are securing it. Next, replace any gaskets, install the new pump, then the pulley, and then the timing belt.
The water pump is located behind the timing belt inside the timing belt cover. It is also attached to the water neck for the lower radiator hose. If you've never done a T-Belt seek supervision.
It is behind the timing case cover behind the crankshaft pulley.You have to remove the timing belt to replace the water pump for this repair.
If you are talking about the timing belt it should run $350 or so. When you get the timing belt replaced-replace the water pump as well. Anothe 100 or so for parts, but labor is the same as the timing belt.
Hi Its located under the timing belt cover......better plan on replacing the timing bet too
first thing that you do is tame off the timing belt cover. then you remove the timing belt. there are two components on the engine that are driven by the timing belt the lower one is the oil pump the upper one is the water pump then you locate and remove the bolts for the water pump. pull the water pump off then replace with new water pump and gasket.