no but you need to install a pilot bearing in the back of the crankshaft to accept the spline for the tranny
It would be a lot more than just installing a bearing in the crankshaft!
You could end up by having to change the engine, you need gear lever connections, you might even have to have a new ECU, cost hundreds.
You can contact your local wrecking yards and try to locate the same vehicle you have only in a standard shift. The vehicle may be damaged from an accident but you would have all the parts needed to change over, every nut and bolt.
Engines with automatic chokes also usually have an automatic throttle which is supposed to run the engine at the best speed. Changing the choke would probably also require coming up with some way to change the throttle.
For most engines there is no need to change the crankshaft to use an engine for an automatic or a manual transmission. For an automatic, connect a flex-plate to the crankshaft. For a manual transmission connect a flywheel.
To change an automatic galant to a 5-speed, you need a Computer for the Manual transmission of that year, and an engine.
If youre changing over a Taurus and its not an SHO then you will have to swap out the entire engine. SHOs were the only ones offered with stick and the manual transmission will not bolt up to a regular Taurus's engine.
Yes u MUST change the computer if you are changing the transmission from auto to manual (visa versa). The computers are different for the especially where the trannirs are concerned.
Though it could be technically possible, it's probably not financially responsible. It would likely cost more than an automatic 1999 Subaru Outback with a rebuilt engine. The main problem would be in changing it from manual to automatic. Or, there are no automatic/manual "engine's", the engine IS separate from the transmission, this is an easy swap provided you have th skills, the wiring harness and ECU will need to be swapped as well.
a turbocharger works on the engine only, it does not matter if the gearbox is manual or automatic
Most likley, what is the make of car and year engine size?
wich one radiator, engine or transmission (manual or automatic)... wich one radiator, engine or transmission (manual or automatic)...
automatic tap changing transformers can change their tap setting on their own, manual tap means a person has to manually go out and change the tap setting
well youll probly have to change the tranny if you changing the engine
there isn't a difference cause theres no such thing as a automatic or manual engine. there is such thing as a manual transmission aka trans. and a automatic trans. the automatic shifts by hydrolic pressure that increases when acclurating. and a manual trans the person driving the vehical shifts the gears with a lever. i hope that's what you wanted to know.