Want this question answered?
Primary Means, it is individual there is no dependence, But Secondary will allays depends on Primary, If you want to do Secondary, you should complete primary first, There is no precondition to primary, but for Secondary Primary is the Precondition, first you should do primary, then only you are able to do secondary.
A secondary Relationship is anything outside of the primary relationship. If you have a wife(Primary or should be) and a girlfriend(Secondary). This is what a secondary relationship would look like and this is an inappropriate relationship.
If the number of turns in the primary is the same as the secondary, this would be an isolation transformer. Primary and secondary voltages should match (minus the inherent transformer losses), as should the current.
For raging paedophiles.
When the primary and secondary voltages are the same the transformer is being used for isolation. The secondary side will have galvanic isolation from the primary side. The purpose of the is to protect secondary load if a fault occurs on the primary side. The impedance of the transformer will limit the fault current on the secondary which should save equipment.
You should or you customer WILL be PISSED for having to do the leg work of getting the information of what the primary paid and getting it to their secondary.
It depends on the turns ratio between the primary and the secondary. If the ratio were 10:1, a step-down transformer, for instance, the current in the secondary would be about 50A. If it were 1:10, a step-up transformer, however, the current in the secondary would be about 0.5A.AnswerThe primary current doesn't determine the secondary current. The secondary current is entirely-dependent on the secondary voltage and the impedance of the load. It is this secondary current that the determines the primary current. So you should be asking, "What value of secondary current would result in a primary current of 5.0 A?"
If you have a primary /secondary, the chilled water should be constant at the primary loop. The secondary can be variable. The air seperator is always connected at the return water side and is most likely very effective at the primary return. However is a must as well on the return side of the secondary.
A voltage transformer takes a primary voltage and steps it down to a smaller secondary voltage. This type of transformer will attempt to keep the secondary voltage at a specific ratio of the primary voltage. If you short it, massive current flow in the secondary is required to do this. For a similar reason a CT should never be open circuited - because it attempts to push a specific ratio of primary current through the secondary. If you open circuit the secondary, it takes a massive voltage on the secondary to accomplish this.
after getting the payment from medicare (Primary) then secondary (X/Y/Insurance should pay even if there is no auth. And only this happens if secondary insurance follow medicare guidelines.
Secondary insurance will not pay the claim but the remaining charges should not be billed to the member/patient. Provider of service should write off the patient responsibility that primary insurance applied.
first you should obtain the explanantion of benefits from your primary. it should indicate what the write off amount is. if you're not sure, call the insurance company and ask them. then do the same with your secondary. the secondary insurance will consider the amount allowed by the primary and will usually base their benefits on that. if you are lucky, between the two, you should have little out of pocket expenses.