Push the cover back toward glass. Push in about 1 1/2" on each side of the edge facing you and it should release two plastic molded hooks. Lift up and pull forward to release the back slide in attachments. Entire assembly should now be out and you can remove the bulb socket to replace bulb.
To reinstall, slide assembly back molded hooks in first and push all the way back. May have to push on assembly edge closest to you to get the front two hooks to go into their retaining holes. Once assembly is flush with deck, pull the assembly forward, toward seat back, to make sure front hooks engage properly.
How do you replace the third rear brake light in a 2005 buick allure
How to change third brake light in 2009 Hyundai sonata
BMW servise
remove tail light and reach through
the screws come off and you replace it
Remove the two screws holding the third brake light lens on then remove the lens, it may be stuck but it will pop off. Replace the two bulbs in there by pulling them straight out.
The third brake light on a 2007 Toyota Avalon is replaced by first removing the rear, retaining screws. The wiring harness can then be disconnect and the light bulb removed.
the third brake light is direct from brake light switch no fuse
Begin by removing the wiring harness from your third brake light. Remove the third brake light retaining screws. Reverse the process to install your new third brake light.
Take out the two screws and replace one or both of the lamps.
Its a whole led unit replace whole deal not bulb
Bulb is probably defective. Replace it.