With the ignition turned off, remove the 15 amp "stop" fuse located in the fuse box in the car to the left of where the drivers foot is when sitting in the drivers seat. Remove the fuse for a minute and then reinstall the fuse.
You can also remove the negative battery cable for a minute or two, but you will then have to reset the time and radio stations on your radio.
Answer
There are three ways to shut off the 'check engine light' discount battery (not recommended), use a scan tool and delete code, or wait 40 to 80 key cycles depending what the code was set for. Now, if you dicount the battery for around 5 minutes the check engine light will come off, BUT all memory will be lost. Therefore the vehicle would have to "re learn" new criteria/values. Oh yeah! It will come back on as soon as the symptoms are seen again + you won't pass emssions. A scan tool is a decent way (only if vehicle was fixed), BUT when you delete a code you erase freeze frame data and of course the code itself making it harder for the next tech to fix the problem. Finally, the best way is key cycles AKA warm up cycles. If the car is properly repaired after 40 (type B misfire) or 80 (type A misfire) if the PCM doesn't see the problem occur it will automatically erase the code. Hope that helps out and sorry for being a smart A$$..
To reset the check engine light in your 2006 Toyota Corolla, you will need to attach the car to a diagnostic computer. This allows you to pinpoint the reason for the light coming on, select the correct sensor, and reset the light.
Go to Autozone or Advance Auto and borrow their OBD2 scanner and reset it. Easy and free to use
Try unhooking your battery cables for a few minutes. That usually works for me.
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
The check engine light has to be reset with a OBD scan tool
You reset the check engine light with a scan tool after repairing the failure.
You reset the check engine light with an OBD2 scan tool. But first you must repair the problem that caused it to come on. If not it will just come back on again. There is a problem that is effecting emissions.
Here a answer maybe CHECK THE ENGINE:) the light will go off
hoe do you reset the check engine light in a 1995 land rover
how do i reset the check engine light on a 1999 acura 3.2tl
The check engine light comes on in a car when there is a problem with the engine. It will go off or be reset when the problem is fixed.
How do you reset maint read light on 2010 corolla