To properly adjust the headlights
1. You must first park the vehicle on a level surface 25 feet from a vertical wall or screen directly in front of it.
2. Measure the height of the headlamp bulb center from the ground and
mark a 2.5 meter (8 foot) horizontal reference line on the vertical wall or
screen at this height (a piece of masking tape works well).
3. Turn on the low beam headlamps to illuminate the wall or screen and
open the hood.
4. On the wall or screen you will observe an area of high intensity
light. The top of the high intensity area should touch the horizontal reference line, if not, the beam will need to be adjusted.
5. Locate the vertical adjuster on each headlamp. The vertical adjuster is located on the rear of the headlamp between the two retainer pins. Using a 4 mm wrench, turn the adjuster either clockwise (to adjust down) or
counterclockwise (to adjust up). The horizontal edge of the brighter light should touch the horizontal reference line.
6. HORIZONTAL AIM IS NOT REQUIRED FOR THIS VEHICLE AND IS NON-ADJUSTABLE.
7. Close the hood and turn off the lamps.
The idle is not adjustible. You may need to clean the throttle plate to improve the idle.
Where is ignition control module on a 2001 mercury sable
my car has a code p1309 2001 mercury sable. What is the problem. thanks
On a 2001 Mercury Sable : The battery is located in the front of the engine compartment , on the drivers side
location for fuse, and relay switch on a Mercury Sable
how do i change out a power steering switch on a 2001 mercury sable with a 3.0 engine?
On a 2001 Mercury Sable : No , just front wheel drive according to my Consumer Guide book
on the dash
trunk
I was looking at the 2001 Mercury Sable Owner Guide and it mentions a TRACTION CONTROL on / off switch located to the right of the instrument cluster
The rear speakers in a 2001 Mercury Sable measure 6 inches by 8 inches. These speakers are located in the rear deck of the vehicle.
The 2001 Mercury Sable does come with a CD player. If the car does not have a CD player in it, an install kit can be purchased to install a CD player.