0
The brake lights on a 1998 Mercury Sable are changed by removing the retaining screws, pulling the light assembly away from the vehicle, and removing the bulb. A new bulb can then be installed and the assembly put back in place.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What is the size of rear brake lines on a 1998 Mercury Sable?
3/16
No brake light on 1998 Mazda pickup?
If there is no brake lights on a 1998 Mazda pickup, check the fuse. If the fuse has blown, the lights will not work.
What does ip mean on the dashboard Mercury Sable 1998?
If you mean the exclamation point and the " P " above the word " BRAKE " in the lower right side of the gauge cluster in a 1998 Mercury Sable that means either the parking brake / emergency brake is on , or the brake fluid level in the brake master cylinder in your engine compartment is LOW
Why do brake lights affect the gear shift 1998 town car?
There is a shifter interlock switch on the brake pedal which also controls the brake lights
Why are the brake lights not working in a 1998 Plymouth voyager?
try the brake switch on the back of the brake pedal
What fuse controls brake lights?
What fuse controls the brake lights on a 1998 Chevy Camaro? It should be labeled on the fuse block.
What is the fuse number for the brake lights on a Peugeot partner van?
Where's the fuse situated for brake lights on a Peugeot partner 1998
Why might the brake lights not work on a 1998 Cadillac Catera?
Bad brake light switch
What could cause the bottom brake lights on 1998 Explorer to be out while the dash lights and backup lights work?
Blown fuse or defective brake light switch.
How do you change front brake rotors on a 1998 Hyundai Accent?
Change front brake rotors on a 1998 Hyundai Accent?
Your 1998 mercury mystique brake lights don't work is there a sensor that needs to be replaced or just a fuse?
check fuses & brake lights switch located on brake pedal
How do you change the brake lights on an Oldsmobile cutlass 1998?
Open trunk and pull carpeting back from the rear lights and you will see wing nuts, take the wing nuts off and pull the complete light assembly out to change the bulbs.
