howdo you change the front axel of a dodge Dakota 2000 4x4
they are in front and after your cat
On the front of the throttle body.
The cam sensor is located under the front of the right front (pass) head.
I think it is near front grill in front of radiator
The cam sensor on a Dodge 4.7L is under the front outside of the passenger side cylinder head.
passenger side front corner of the intake manifold
you look on another site and in the mannual
Front of the throttle body.Front of the throttle body.
1992 dodge dakotas do not have front coil springs, they have torsion bars instead.
4.7 L it is under the front of thr right head. other engines it is in the distributor.
Front of the manifold. 3-wires. (Orange, Black&Blue, and Green&Red)
Front driver side of the engine, just above the oil filter.
Under the very front of the pasenger side cylinder head.
Front side of the throttle body, held in by two torx head bolts.
It is under the front outside of the passenger side cylinder head.
Passenger side of engine about halfway back. Can be seen/worked on through the front passenger wheel well.
Under the front of the right front head.
you have to remove trans.after trans is removed remove tork.conv.check bushing in front pump you will find that it is bad
The oil pressure sensor is on the driver side front of the engine next to the oil filter.
4.7L - front under side of passenger cylinder head. 3.9L, 5.2L, 5.9l, - inside the distributor.
the front are 6.5 and the back are 5.25
The speed sensor, on your Dodge Stratus, is located on the back of the transmission. The speed sensor has a wire leading to the front wheel.
Front driver side.
It is on the left front of engine. Points at the left front cam shaft. UNplug the wire , unscrew bolt, and pull sensor out.