Well it depends on the year. On the 1996-1998 grand am Gt and Se there are 2 push in clips on the top side, under the hood. There are two small screws on both the left and right side just to the outside of the headlights. (you have to remove the headlights) Then you have to get underneath and remove the wheel liner from both sides. Then reach up under the bumper and there are two bolts( i think 10 mm) that hold the bumper to the fender. Once you remove all that hardware, it will just slide off.
you take it off and then you put the new one on!
How do you replace a 1996 Grand Prix front bumper?
First remove the bumper cover. You need to take off the front grill to get at the plastic retainers that hold the top of the buimber on. There are about four retainers on the bootom of the bumper.
take it off and put the new bumper on replacing all screws nuts and bolts from the first bumper
To replace a Pontiac Grand Am bumper cover, start by taking out either the three bolts on the side of the fender or in front of the wheels. Remove the top pushpins to remove the cover. Push back the two pins for each headlight, and pull them up. Unplug the lights. Then, get the replacement bumper, and snap it into place like the previous one.
On my 2000 grand cherokee, It was in front of the battery on the fender wall. Remove battery and you should find it. It is under the bumper cover, under the passenger head light. You either have to remove the front bumper, or you remove the headlight and cut an access hole.
Unbolt the front of the wheel well liner inside the wheel opening.Remove the bumper cover bolt from the bracket located inside of the bumper at the end.AT the front of the car, remove the bolts holding the bumper cover on, located underneath the vehicle.You should now be able to remove the bumper cover from the front of your Dodge Intrepid.An instructional video has been included to show you the removal process.
Not sure *which* light cover is being asked about, but the "Related Questions" below will cover all 3: headlight, taillight & running light in the front bumper cover
how do i change the front bumper on my 1999 vauxhall vetra
Park the Impala on a level surface and engage the parking brake. Remove the keys from the vehicle's ignition.Crawl underneath the front of the vehicle and use a slotted screwdriver to pry off the splash shield in each wheel well directly in front of both front tires. Once the shields are removed, you can access the screws securing the bumper cover to the fender.Remove the two screws on each side of the bumper cover with a Phillips screwdriver.Remove the bumper cover from the front of the vehicle by pulling it up and off the Impala. You may need another person to help you remove the bumper cover. Install a new bumper cover by placing it onto the front of the Impala.Crawl underneath the Impala again and reinstall the two screws on each side of the bumper cover. Reattach the splash shields to the wheel wells.
In the front bumper. Drivers side3.
They are usually just inside the Front Bumper Cover. There should be wires attached. These are the ones that activate the Airbags.