answersLogoWhite

0

How to change coolant on Celica vvti?

Updated: 12/8/2022
User Avatar

Wiki User

12y ago

Best Answer

50/50 water/coolant

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How to change coolant on Celica vvti?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What causes a misfire on totota celica vvti when engine hot?

its the throttle position sensor


Toyota Celica vvti no hot air engine overheating?

If the Toyota Celica VVTI is not blowing hot air through the heater, but the engine is overheating, there could be a problem with the radiator being plugged up. Sediment sometimes builds up in the radiator that can clog thermostats. Another problem might be the thermostat sticking or the water pump is leaking.


I put the wrong oil in my car 2001 celica vvti but it was only a small amount and done a complete oil and filter change a week later but you hear a knocking noise when its driven with the engine cold?

Noisy cams, this is normal! no its not normal. it only started after the oil change


How much coolant does an 2002 Celica take?

3.7 litres


What is effective to flush out coolant on Celica 2000 GT?

water


What is faster Toyota supra or Toyota Celica vvti?

Ok there are a lot of factors to this one: 1. The Supra has a bigger engine as well as more torque and hp 2. The Celica is smaller and lighter. 3. The driver. In my opinion the Celica will beat the Supra in a short drag but the Supra has the power to pull off the longer runs.


Why 1996 Celica overheat when idle?

Could be a plugged or restricted radiator Low coolant? Water pump not circulating coolant?


Does the Nissan x trail engine have vvti?

vvti timing


What does the I initial on a car mean?

Usually states that the engine has a fuel injection system. An example could be a Rover 214 Si which would be Sports injection. Or a Toyota Celica VVTi for Variable Valve Timing Injection.


What does the code p1349 vvt system refer to on an 03 rav 4?

p1349 refers to the variable valve timing, the computer sets this code when it commands the vvti control valve to apply oil pressure to the vvti assembly on the front of the intake camshaft to adjust cam timing and there is no change. the couse could be low or dirty oil, a bad vvti controll oil valve , stopped oil passages , the vvti assembly on the front of intake cam or a bad ecm.


Who invent vvti?

toyota


How do you change the rear main oil seal in a 2000 Toyota celica gt?

How do you change rear main oil seal in a 2000 Toyota celica gt. thanks