Alternators
How To

How to change the altinator?

1

Top Answer
User Avatar
Wiki User
2010-06-29 11:41:10
2010-06-29 11:41:10

You should only have to take out 2 bolts and take off a belt. When replacing an alternator you usually want to replace the belt to.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

loosen altinator, loosen smog pump, take smog pump belt loose, then take altinator belt over smog pump belt and over fan

User Avatar

See related answers, its been asked and answered repeatedly.

User Avatar

how do u lossen the altinator belt on a 91 honda accord

User Avatar

Voltage regulator built into the Altinator is bad. Replace voltage reg or whole altinator

User Avatar

Instructions with pictures can be found here:http://www.rdtiburon.com/index.php?showtopic=30576&hl=alternator

User Avatar

first romove the altinator belt then from under the car detach the altinator harness connectors then remove the lower bracket then remove the adjusting bolt then last remove the bolts and take the altinator out it might be a little tight but it will come out from under the car

User Avatar

Remove belt pressure via the tensioning pully. Remove belt from alternator pully. Remove negative battery terminal. Disconnect wiring. Remove bolts. Remove altinator. Replace altinator. Reinstall bolts and connect wiring. Reinstall belt and negative terminal. It should take around 20 minutes.

User Avatar

probly buitl in to the altinator drive safe

User Avatar

how to replace an altinator in a 2005 nissan altima

User Avatar

it loacted jus underneath the altinator , in a radiator hose

User Avatar

how to install a altinator on a 1991 acura integra

User Avatar

You'll have to loosen the alternator to get the belt off, unless you have a tensioner pulley in the sequence of the serpentine. yes it removes the tension to make it easier just did it last weekend.

User Avatar

the water pump is in with the timing chain, and is very hard to get to. If you will look under your exuast manifold you will see it to change it you have to your manifold off,altinator,belts, balancer,exc just have someone do it

User Avatar

some times it is the problem of altinator becoz it wont getspark to start the engine but if altinator is ok then you have to try the fuse points... may be they get loose, and if still its not working then search the nearest garaze my dear/..........

User Avatar

when looking at the front of the engine it is below the altinator slightly to the right

User Avatar

hi it could be a dodgy altinator .start there

User Avatar

as in most chevys starter, water pump, and altinator

User Avatar

Bad battery? Could be the wiring harness in the charging system. If the replacement alternator was a used part, it might also be bad (yes this has happened to me).

User Avatar

on the right cylinder head (passenger side). takes two brackets

User Avatar

Depend on what make and model vehicle you are installing it on. Any auto parts store can quote you the price.

User Avatar

Easier than you think remove heat shield from headers then remove the top bolt of the altinator loosen the bottom one then remove belt remove positive and negative wires with socket wrench then hold altinator and remove bottom bolt fully.

User Avatar

My DIC for my 2000 gtp would flicker then go out. On start up it would work then go out,eventually it went out for good.I changed the ignition switch,battery,checked all the wires i possiblly could under the hood and nothing.Changed the altinator,but was not the problem.I took it in and quality electric hooked a wire off the altinator and bypassed something ,not exactly sure what he did but it was not much.Check the altinator wires .He charged me 60 bucks.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.