Changing the spark plugs on a 1997 Ford Expedition 5.4L engine takes patience. Remember to start this project on a cold engine! I started on the passenger side by locating the Coil over iginition coils and cleaned out all the old dirt using some compressed air. Then I had to disconnect the electrical connections to both the Coil over ignition coils and the passenger side fuel injectors. Once you remove the small bolt which holds the ignition coil in place, use your compressed air again to blow out the spark plug hole. After that, you will need a 5/8" swivel spark plug socket and various length extensions to remove the spark plugs. Take your time because there is not much room for your hands. Before installing the new plug, check the gap and use clean engine oil on the new threads. Tighten the new spark plug and reinstall the coil over ignition coil. Reconnect the electrical connection to both the ignition coil and the fuel injector. Continue these steps with all eight spark plugs. You will find the ones on the drivers side are difficult because of the fuel rail gets in your way. Have patience and use swivel extensions to work around the tight spaces. When you are done, you will have saved lots of money! Don't forget to replace your air filter, fuel filter, and pcv valve to complete your tune up.
Where and how do you find the spark plugs for a 1997 ford expedition?
Yes , it has 8 spark plugs
To change the spark plugs in a 1997 astro van do I have to change the spark plugs from the bottom of the engine/
There 8 Spark plugs not 4.
Where are the spark plugs located on a 1997 jetta gl
With a Spark plug Wrench
how many spark plugs are in a 1997 kia?
You can change the spark plugs on the 1997 Toyota Tacoma yourself. Remove the ground wire and spark plug wire. Remove plug. Replace the plug with a plug made specially for your model car.
Remove the fuel tank, Remove air box, Remove spark plug caps, Remove spark plugs ????
Remove the spark plug wires from your 1997 Chevy Express 5.7 liter engine spark plugs. Remove the spark plugs with a 5/8 deep well socket, by turning the socket to the left. Reverse the process to install the new spark plugs.
Check the Vehicle Emissions Control Information ( VECI ) decal located in the front of your engine compartment ( it will show the type of spark plugs that are used and the spark plug gap )
you have to through the wheel wells to ge to spark plugs. use a long extenison and a spark scocket with a sweival built on to it. good lock