the part of the transmission where the fluid goes is on the drivers side part of the transmission. its right above the transmission temperature sensor and its the biggest bolt head right above the transmission temp sensor
To add brake fluid in a 1990 Mazda Protege, you need to locate the brake fluid reservoir and check the levels. The reservoir is located on the master cylinder for the brakes.
A 2001 Mazda Protege has a seal system, meaning the car does not have a dipstick to check the transmission fluid. It is best to take it to a dealership to have the fluid tested, but a person can check it by slightly pulling out the plug under the car, and see the condition of the fluid coming out of the plug.
where do you add clutch fluid on a Mazda 1997
You have to disconnect the speedometer cable to check it. There are no marks but halfway up the gear is where the fluid should be. Then pump fluid into it if its low.
it uses the "extra" fluid from the brake reservoir, so just check that you are ok on brake fluid and your clutch should be fine
There is no stick on a manual transmission, you check the fluid with the fill plug
There is no stick on a manual transmission, you check the fluid with the fill plug
75w 90
power steering fluid resivour
brake fluid
Check for bad clutch master cylinder or slave cylinder.
Should be a plug at the side of transmission - fill to oil starts coming out of this plug