Start the bike up and ride it or let it idle for a few minutes to war the oil up in the engine. Then kill the engine and loosen the drain plug on the bottom of the engine. Let all of the oil drain out and replace and tighten (careful to not overtighten) the drain plug.
you dont, drain the oil and start again
Run engine to warm up the oil undo sump plug drain old oil. Replace with the correct oil and amount.
The bottom back side of the cases by the countershaft (facing the rear wheel).
Start the bike up and ride it or let it idle for a few minutes to war the oil up in the engine. Then kill the engine and loosen the drain plug on the bottom of the engine. Let all of the oil drain out and replace and tighten (careful to not overtighten) the drain plug. Remove the filler plug and add your oil.
Engine oil, KTM recommends Motorex ATF Super (Dexron II Gear Oil) Premix, KTM recommends Motorex 2T.
Start the bike up and ride it or let it idle for a few minutes to war the oil up in the engine. Then kill the engine and loosen the drain plug on the bottom of the engine. Let all of the oil drain out and replace and tighten (careful to not overtighten) the drain plug. Remove the filler plug and add your oil.
On the bottom side of the cases either in the center or at the back (towards the rear wheel side of cases).
hw much gearbox oil do you put in your ktm 525
How much engine oil do you put in a ktm 85
what oil is used in a ktm 65
Start the bike up and let the oil warm up (side of the cylinder should be pretty warm to touch) before killing engine. Remove drain plug (on bottom of engine) and let all oil run out. Replace drain plug and remove filler plug on side of cases and add oil.
The engine oil capacity for a 2010 KTM 250 XCF-W is 0.75L. It is also stated that the best oil to use for the 2010 KTM 250 XCF-W is the 10W-40 bike oil.