Windshields and Wipers
Ford Windstar GL
DIY Projects
How To

How to fix windshield wiper transmission?

585960

Top Answer
User Avatar
Wiki User
Answered
2015-07-16 18:20:39
2015-07-16 18:20:39

I drille a hole in the top of the case and poured in some gear oil. It worked for a year or so.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


You have to remove the linkage from the wiper motor.

To fix windshield wipers on a Volvo 940 try using new wiper fluid and cleaning the windshield and wiper blades before you replace the blades. It is also important to replace wiper blades regularly.

ughh i have the same problem. you need to fix the windshield wiper motor

The wiper arm is attached to the pivot which is part of the wiper transmission, which in turn is attached to the wiper motor.

The wiper transmission has broken due to the linkage seizing. You need to replace the transmission......To do this you nedd to remove the top of the dash as there are 2 bolts hidden on the indise of the car to get it out

If the passenger wiper works, either the drivers side wiper arm or the windshield wiper transmission is defective. The linkages that work the wiper arms is called a transmission.

The wiper motor is a non repairable part, just replace it.

Check for disconnected or broken linkage or a bad wiper transmission

How do I replace the windshield wiper switch?

If the wiper motor is good and the motor shaft turns when the wiper is on then you need to check the linkage for the wiper arm. the rear wiper motors and switches are notorious for going bad in the jgc you may have lost your switch.

# Remove the wiper arms # Remove the windshield wiper cowl cover # Disconnect the electrical connector from the wiper motor and remove the motor # Remove the wiper motor retaining bolts # Pry the linkage arm off the wiper motor pin with large screwdriver

take it to your gm dealer it was a recall

i put a new windshield wiper moter in and the fuses are fine but my wipers still wont work

If a windshield wiper switch on a 1995 Buick Riviera stays on when in the off position, it might be the fault of the windshield wiper relay. It could also be that the switch itself needs to be taken off and reset on the dial.

check linkage assymbely or the transmission mounted on the wiper motor. you might have a bad wiper transmission.it will be only $34 change it should fix the problem

Mary Anderson patented the windshield wiper in 1905

NOTE: To prevent glass and/or paint damage, do not pry windshield wiper pivot arm from windshield wiper mounting arm and pivot shaft with metal or sharp tool. 1. Turn ignition switch to the ACC position. Turn turn signal and windshield wiper switch ON. Allow windshield wiper motor to move the windshield wiper mounting arm and pivot shafts three or four cycles, then turn off the turn signal and windshield wiper switch. This will place the windshield wiper mounting arm and pivot shafts in the park position. Turn ignition switch to the OFF position. 2. Remove the windshield wiper pivot arm and windshield wiper blade by first applying downward pressure on the windshield wiper pivot arm head, while holding the windshield wiper pivot arm. Then lift the windshield wiper pivot arm to the highest position and, using finger pressure only, grasp slide latch tab and slide latch out from under the windshield wiper pivot arm head. Remove windshield wiper pivot arm and windshield wiper blade assembly. 3. To remove the windshield wiper blade, insert a screwdriver into the slot provided at top of the windshield wiper blade frame, push down on spring lock and pull the windshield wiper blade from the windshield wiper mounting arm and pivot shaft . 4. Install the windshield wiper blade onto the new replacement windshield wiper pivot arm. See sources and related links below for replacement wiper blade information.

There was an inventor (of the windshield wiper) called Mary Anderson.There was an inventor (of the windshield wiper) called Mary Anderson.There was an inventor (of the windshield wiper) called Mary Anderson.There was an inventor (of the windshield wiper) called Mary Anderson.

More than likely the problem is the transmission that needs to be replaced

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528003b3db

Replace the locking tab on top of the wiper

Remove the windshield wiper arm from the windshield wiper motor. Remove the wiring harness. Remove the retaining nut. Reverse the process to install the new windshield wiper motor.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.