Completely remove the inside door panel. Since the window is down, the two screws that hold the window glass to the regulator should be easily acessable. Remove these two screws. Disconnect the regulator from the window glass. Push the window glass up to the very top. A bungy cord can be used to hold the glass up while the motor is being removed. Hook the bungy cord to the top of the door. Hook the other end to the bottom of the window glass.
Behind the window winding handle there is a circlip, this a "C" section type clip & can be remove using a thin blade screw driver or you can make up the right tool, which is a thin piece of steel that has a "u" shape taken out. This should do it.
The cable cannot be replaced. Roger (AKA as Einstein by his many friends) said to remove the panel, drill out the rivets and replace the unit.
smash the window and then put a new one in simple
Nobody knows.. Or they wont tell you... Have to take it to the mazda dealer...
Yes, 1999 Mazda protege window issues indeed....
Behind driver seat under insulation is a lid with screws, remove and youll see a fuel pump..... hooray
there is a small clip between the handle and door panel that u have to remove it is easy if u have a small pick to hook it with then to install just place clip on handle and push on the window regulator shaft.
http://forums.mazdaworld.org/index.php?showtopic=432
how do i remove the starter motor Mazda rx8
first remove the front bar cover from driver side second remove the driver side head light,third undo the plastic cover under the driver side guard,fourth remove the windscreen washer bottle.now u can see the electric power steering pump just undo it.
Usually its just a flip up cover and has a screw...unless its a Mazda 626 I'm looking for the same answer haha good luck
how do remove the brake drum on a 1991 mazda 323