Take small flathead screwdriver and remove front faceplate trim. This will just pop out with a bit of leverage. There should be a screw on either side of the radio cage. Remove both screws and the radio should pull straight out. Unplug the antenna lead and the multiplug lead from the radio. Next, look on either side of the dadio cage. There will be two screws holding the radio into the cage. Remove these two screws and the radio will separate from the cage. Take the new radio and insert into the cage. Installation is the reverse of removal. You will probably need an adapter from your radio to the car's multiplug. Also the antenna lead can be a pain to reinstall on the aftermarket radio.
The ecm is located under the front passenger seat on my wife's 2000 Daewoo Lanos. This is an American version of the car.
Under th inlet manifold, you will need to remove the alternator to gain access
Daewoo Lanos was first manufactured in 1997. At this time, they were only manufacturing sedans and the car model was a lot different than most of the more recent Daewoo Lanos cars a person would see on the market today.
To check the transmission fluid on a Daewoo Lanos 2000 you have to get to the back side of the engine from underneath. The way we did it was to put the car on a lift.
is located under the car. well under the engine.
sell your daewoo lanos and buy a diffrent car.
It depends on what mileage your car has. Personally, i use 10w40 and my car has 145k on it.
You should never tow a car with Automatic transmission
The jack points on my daewoo lanos look like little cut out notches on the underside of the body. I have a 2001 Y reg model. Hope that helps. There is a good illustration of it in the handbook if you still have it.
If it is the same as the 2000 Daewoo Lanos, it will be located inside the car on the passenger side. You will have to remove most of the lower dash (black plastic) to find it, there are about 30 (7 mm) screws that need to get removed and the fan will have to come out to access the expansion valve block. The expansion valve itself is held in place with (2) 8mm bolts.
You can get the replacement key at Home Depot, is the car key # 27R
You can easily remove your old car stereo without taking help of a car stereo expert. However, you need to follow some steps and need some tools to remove your old car stereo. You can save your money by following the steps for removing your car stereo otherwise you have to pay more money to the professional car stereo installer.Here are some steps to remove the car stereo safely.First of all, Read the user manual of the car where you can find some tips to remove the car stereo. You may find a diagram of stereo wiring, so it would be more help to you.To remove your car stereo safely, please disconnect the battery to avoid electrical short during working with wires of car stereo.To remove your car stereo from the dashboard use screwdrivers to remove the screw, which is holding car stereo. Furthermore, check that your car stereo connected with dashboard using spring or clips and others.Remove dash panels and take out the bolts and screw which hold car stereo. Now pull out your car stereo.Now you can see there are some wires, which are connected on the back of the car stereo. A wiring of car stereo is protected with clip. You should pull out the wire straight out.For more information about remove old car stereo and want to new car stereo installation, please feel free to visit this blog Houstoncarstereo.com/blog/