0
If replacing the rod itself (e.g., the rod that is "stuck" in the piston) you need a special tool to release the retainer clip. The retainer goes between the rod and inside the piston to prevent the rod from slipping out if the master cylinder or brake pedal comes loose.
If you do not have the tool, you can try inserting a small pick to bend the clip outwards away from the rod and pull the clip out later after the rod is free. Some people have reported banging the rod with a hammer to break the clip, but will certainly distort the eye hole of the rod.
Most people avoid trying to get the rod out and buy an adjustable rod - especially if doing a single to dual master cylinder conversion.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace the third brake light on a 2006 ford mustang?
# Remove the trunklid latch trim cover # Remove the electrical connector # Push in on the tabs and push light out of trunk
Will a 1967 mustang manual brake master cylinder bolt up to a 1966 mustang firewall?
Yes, but you will need to use the original push rod from the 1966 Mustang as it is shorter than the 1967.
Emergency brake push knob broke off how do you fix 98 jeep Cherokee?
You have to replace the parking brake handle assembly.
How do you replace KIA front brake pads I can't get the brake cylinder to retract en?
you have to push the brake cylinder back into the caliper using a "C" clamp
How do you change the rear disks brake pads on a 1994 mustang I cant get the piston to compress do I have to remvoe anything to do with the emergency brake?
it dosent just push back in anymore , u have to turn it , it screws in.
How do you replace ignition switch on a 1964 mustang?
ignition is spring loaded.unscrew dash and push in ignition and turn it comes right out.
Do the fuel rails need to be removed to replace spark plugs on my 2001 mustang gt?
nope just losen and push over nope just losen and push over
How do you release the piston on the rear brake caliper on a 1993 cobra mustang?
If you mean to push them back in as when installing new brake shoes, they have to be screwed in. There is a special tools available, but in a pinch a pair of channel locks can be used.
How do you fix the brake lights on a 2001 f350?
Check the fuse, bulbs or there is a push button switch above the brake pedal that may need align or replace
Are the brakes of a 68 mustang supposed to be hard to push?
Compared to todays modern brake systems they will feel hard. Also depends on if they are power brakes or not. Some cars of that era did not have power brakes and they were very hard to push.
How do turn off the parking brake light in 1990 Chevy Astro?
When the brakelite switch fails it fails to on. Replace the brakelite switch. Located under the dash on the brake pedal arm. You will see a push switch that is released when the brake is pressed. Just replace that switch.
How do you replace the windshield wipers on a 2000 Ford Mustang Gt?
PULL THE WIPER ARM UP AND ON THE BOTTOM OF THE BLADE YOU WILL SEE A LITTLE PUSH TAB, PUSH THE TAB AND PULL THE BLADE DOWN! GOOD LUCK
