lift hood pull plug wires loosen two Phillips screws lift cap off you should change roter too by pulling it straight up install new roter set new cap on tighten screws replace plug wires with new ones find 1 on new cap that
is were you start fireing order is driver side from front of motor 1357 pass side is 2468 start with number one on cap and go clock wise 18436572
A Dodge Neon does not have a distributor.
Clutch slave is seled unit. replace clutch
That engine does not use a distributor.
Will a 1992 Dakota truck motor fit into a dodge truck 1999 Dakota?"
In the distributor.
Inside the distributor. Replace the whole distributor.
I have never heard of a mixer on a dodge truck.
how do replace the thermostat on a 1999 mazda b2500 truck?
Yes they will. Anything from the year 94-01 will fit with all parts of the truck.
From behind the light bezel (under the truck) quarter turn and remove the lamp holder. Replace with an "893" type bulb
On top of the engine in back of the throttle body.
It is a non serviceable part of the distributor. The distributor has to be replaced.
The cam shaft position sensor is located under the distributor cap. You can replace this easily by undoing the screws holding on the distributor cap, remove and replace the sensor, then just replace the distributor cap.
Inside the distributor, under the rotor. It is called a pick up plate.Inside the distributor, under the rotor. It is called a pick up plate.
A 1999 Dodge 360's distributor is set to 0 deg with the sacn tool. This can not be done with a timing light.
With another Headlight Assembly that is made for a 1999 Dodge Durango.
A 1999 Dodge Caravan does not have a cabin filter.
there is no cap it has a coil for each plug wire on the motor remove one wire at a time and replace it
Remove old one and follow same routing--make sure to "bleed" system when done
Back of the engine, next to the distributor.Back of the engine, next to the distributor.
It is in the fuel tank.
It doesn't have one.
The spare tire is under the rear of the truck.