This isn't a terrible job, but if I were you, I'd pick up a Haynes or Chilton manual for
the car. You really need to be able to read the procedures and see the illustrations.
You will need to check the drums/rotors to make sure they are in spec to be resurfaced.
How do you replace the third rear brake light in a 2005 buick allure
where is the starter located on 2005 pontiac sunfire
support employment - take it to a mechanic!
Yes, the shoes have an adjustment on them.
You do not need a scan tool to replace any brake pads. The wear is obvious.
This "question" isn't even a question.
To change the brakes a person lifts the car, removes the wheel, removes the brake shoe and the old brake pad. Next the person puts in a new brake pad, replace the brake shoe, replace the tire, and then lower the car.
about 3 dollars
Lift the car, remove the tire, remove the brake caliper, and remove the old brake pads. Put in the new brake pads, replace the brake caliper, replace the tire and lower the car.?æ
Look under the vehicle - follow the fuel line from the tankRemove clamps and support to replace
Lift the vehicle on a jack, remove the tire and set to the side, remove the brake shoe/caliper, and remove the old brake pad. Throw away the old pads, put in a new brake pad, replace the brake shoe/caliper, replace the tire, and lower the vehicle to the ground.
I have a 1800 vectra and the break light comes on when traveling then goes off, is this the brake shoes or pads wearing out.