answersLogoWhite

0

take off the cap...mark were the distributor meets the engin block.....unbolt the two bolts pull out distribotor...when you replace match up marks and turn rotor back or forward a little till shaft slips in...never force any thing/////o remove the wire conected to it..fits only one way....it real easy

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Does 1996 dodge ram 1500 4x4 5.9l have distributor and rotor or coil pack?

Distributor and rotor.Distributor and rotor.


Where is the rotor cap located on a 1996 astro van?

It's the distributor rotor that you are looking for & it's under the distributor cap. Remove the distributor cap and there you will find the rotor.


How do you remove the distributor cap and rotor on a 1996 Chevy Caprice?

you dont


How do you replace the cam sensor on 1996 dodge 5.2?

Unbolt distributor cap. lift rotor off, remove and install new cam sensor (pick up plate) and reinstall rotor and cap.


Where is the rotor button on a 1996 dodge ram 1500?

Under the distributor cap.


How do you change the distributor on a 1996 Nissan 240SX?

buy a new distributor cap and rotor. Unscrew the distributor cap (on the drivers side of the engine block), take note how the existing rotor is sitting, remove it, and place the new rotor in the same position. Put on the distributor cap and screw it into place... very simple job. thats how you change the rotor......he asked about the distributor....try again.


How do you remove the rotor from a 1996 ford bronco 4x4?

If you mean the rotor from inside the distributor. Just unclip the 2 clips and lift up the distributor cap then use a nut driver to remove the 2 bolts on the rotor.


What causes 1996 Mazda millenia to misfire on cylinder 1?

Start with a bad Spark Wire Followd by a new Distributor Cap and Rotor button. Pening that failure, replace the sparks.


Where is the camshaft position sensor on a 1996 gmc jimmy?

It is located on the distributor under the cap and rotor.


How do you tune up a 1996 Nissan Sentra?

Replace the spark plugs, spark plug wires, spark plug rotor & distributor, put in new air filter & change the fuel filter.


How do you replace the camshaft sensor on a Chrysler Sebring 1996 2.5l v6?

The cam sensor is part of the distributor. You have to replace the entire distributor.


Will a new distributor and rotor start your 1996 Chrysler Sebring jxi?

If the old part had failed, yes.

Trending Questions
What is the grinding noise in front of Honda CR-V when turning? How many engine mounts does a 2001 suzuki esteem have? Where is the circuit opening relay located 2001 Toyota corolla? What causes a 1996 Mazda b2300 pickup to misfire? How do I remove a 1990 Lexus es250 radio? The cup front cup holder is stuck closed on my 2005 Lexus ES 330. Does anyone know how to open it? Can you put a 96' civic front end on a 93' civic? 4 Name and describe the management challenges posed by IT infrastructure? What is wrong with a 2007 Nissan sentra when the red brake light stays on and keeps beeping? Chinese symbol for unconditional? No ac or heat air coming through the vents on Mazda mx6? Where is the Fuel Fiter located at on a 1997 Suzuki Esteem? How do you remove and install a 1998 Nissan altama idler tension pulley The pulley the space between the pulley and body of car is only about an inch does not have enough room to pullout? Are Daewoo dtec engines good? What colors are the starter and power wires on 96 acura integra? Where is the transmission dip stick located on a 2005 Mitsubishi galant GS? Where is the fuel pressure regulator located on a 1994 Mazda Protege and how difficult is it to change? Where is the fuses for a 1999 tacoma tow harness? How do you start a honda civic 1.4i that has not been used in 2 years it has half tank fuel still and ok lvl of oil tried jump starting it an using wd40 on spark plugs? How do you change the language on your kia forte from french to english?