answersLogoWhite

0


Best Answer

First you need a ratchet with 3 socket sizes. 7,10, 15...Empty out gas tank as much as possible first........there is two size ten bolts behind the license plate on the side on the gas cap, remove. Go under the car jack up from both sides near passenger doors. Right behind the gas tank closes to back of the car there is a wire connection take off. Behind the back end of the fuel tank closes to front of the car there is two covers each has 4 bolts size 7, remove. If you look up at the fuel lines there is 3 wiith a brace bracket holding them in place remove bracket by hand. After that you will see two bolts which are size 15. One on each side. Slowly remove and have a helper unless you can with hold the weight. by than you will have thank on the floor.If you look at the top of the tank you will see 6 bolts hold down where your fuel pump is. remove bolts but remember how the holes are align. slowly take fuel pump out replace fuel filter n pump and fuel sending unit if necessary. I would either way. now reassemble. Also make sure to take off the battery terminals and fuel fuse which is number 13 under your fuse block under the hood. I did this too my 94 fleetwood today alone. Simple job but make sure you have block or anything to help level the tank to align fuel pump back in.

User Avatar

Wiki User

βˆ™ 13y ago
This answer is:
User Avatar
More answers
User Avatar

Anonymous

Lvl 1
βˆ™ 3y ago

That’s what I want to know????

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How to replace fuel pump on a 1993 cadillac fleetwood brougham with 5.7 liter engine?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Coolant temperature sensor for a Cadillac Fleetwood Brougham with a 5.7 liter engine?

sensor for water temp is in water pump on front of engine, has two wire plug going to it.


My 1990 Cadillac Fleetwood Brougham hearse has the 5.7 in it was thinging of a weiand blower is it the same intake as the Chevrolet 5.7?

The optional 5.7 engine used in the '90-'93 Cadillac Broughams is the Chevrolet 350.


Where is the Coolant temperature sensor for a 1993 Cadillac Fleetwood Brougham with a 5.7 liter engine located?

It is located near the front of the motor, near the thermostat, screwed into the block.


Why does the check engine light on a 1994 Cadillac Fleetwood come on?

it could be so many diffrent things google "error codes for a 1994 fleetwood brougham" it will send you to myweb.accesuss.com or .net..very usefull in tracking down the cause


Where is the coolant temp sensor located on a 1994 Cadillac fleetwood brougham 5.7l engine?

There are two coolant temperature sensors. One is located near the water pump and the other on the head above the starter.


Cadillac engines from 1980 to 1992?

.112= 1.8 .121= 2.0 .173= 2.8 .249= 4.1 .252= 4.1 .262= 4.3 .273= 4.5 .300= 4.9 .307= 5.0 .305= 5.0 .350= 5.7 .368= 6.0 In 1980 Cadillac offered a .350 diesel engine as standard equipment for the Seville and optional equipment for the Fleetwood Brougham and Eldorado. The gasoline .350 was optional for the Seville and Eldorado. They offered a .368 as standard equipment for the Fleetwood Brougham, De Ville, and Eldorodo, and as an option for the Seville. In 1981, the .252 V6 (built by Buick) was offered as an option for all models. The .350 diesel was still standard for the Seville and option for the Fleetwood Brougham and Eldorado, and it was offered for the De Ville. The .350 was not offered in gasoline. The .368 was made a the V8-6-4 variable displacement engine and was standard for the De Ville, Brougham, Eldorado, and Optional for the Seville. The .368 that was used in 80 was available for commercial chassis only. In 1982, the .112 straight 4 was available for the Cimarron. The .249 was introduced and made standard for all Models, except the Cimarron. The .252 and the .350 diesel were made optional for all Models, Except Cimarron. The V8-6-4 was made standard for all limousines while the .368 was standard for all other commercial chassis. 1983, the Cimarron was upgraded to the .121 engine. All stayed the same until 1985. 1985 the Cimarron received a .173 V6 engine as an option. the .249 was made standard for the Fleetwood Brougham, and limousines. A higher horsepower front wheel drive, .249 was standard on the De Ville Seville, and Eldorado. A .262 diesel was offered as an option for the front wheel drive cars and the .350 diesel was optional on the Fleetwood Brougham. In 1986 the Fleetwood Brougham line split into two lines; the Fleetwood and Brougham, where the Brougham remained rear wheel drive and the Fleetwood became part of the De Ville line and front wheel drive. The .249 was standard equipment on the Fleetwood, De Ville, Seville and Eldorado. The Brougham received an Oldmobile .307 as standard equipment. In 1987, the Cimarron's optional .173 became standard equipment. Cadillac added the Allante to its line, and it received the .249 engine. All other engines stayed the same. In 1988 Cadillac added the .273 engine and made it standard equipment for the Seville, Eldorado, De Ville and Fleetwood. In 1989 The Cimarron was discontinued and the Allante was upgraded to the .273. The Brougham continued with the .307 for both years. In 1990, the .350 gasoline engine was brought back and made as an option to replace the Brougham's .307. For 1991 and 1992 the .307 was replaced with a Chevrolet .305 and the .350 was still optional. Cadillac added a new .300 engine for the De Ville, Seville, Fleetwood, and Eldorado. The Allante retaine the .273.


Where is the thermostat on a 1992 Cadillac brougham?

Top middle part of the engine.


What is the engine oil capacity for a 1985 Cadillac Fleetwod brougham?

5 quarts


What size engines will fit into an 86 fleetwood brougham rwd?

While your standard 5.0 liter (307 cubic inch) engine will fit into your '86, you can put a larger or smaller engine in there. I have seen an '86 with an 8.2 liter (502 cubic inch) engine in it, taken from a 70-75 Eldorado and I have done the same with my '87 Fleetwood Brougham.


What type of motor was the 5.0 liter that came in the 1989 Cadillac Brougham Was is a GM or a Cadillac motor?

the 5.0 is a GM engine..Vin Y was an Oldsmobile engine... they also used a 5.0 Chevy engine but neither were a Cadillac engine


What is the spark plug gap for a 1990 Cadillac Brougham 5.0 liter engine?

60 persent


Will an engine from a 1965 Oldsmobile dynamic 88 fit into a 1979 Cadillac fleetwood successfully?

not at all