0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace rear signal bulb 2002 Pontiac firebird?
raise the hatch pull down on the carpet, determine which light is out and twist to come out, you dont replace from the outside of the car!!!
How do you replace the rear turn signal bulb located on a 2004 Pontiac Grand Prix GT?
pull the lining of the trunk away from the back of the trunk
How do you replace the front turn signal bulb located on a 1989 Pontiac Sunbird?
On some cars the bulbs screw in from the rear and you have to take the light assy off to get to it.
How do you replace the rear turn signal on a 1999 Acura Integra?
When replacing the rear turn signal on a 1999 Acura Integra open the trunk. Locate the rear turn signal housings and find the bulbs. Remove and replace the bulbs.
How do you replace the rear turn signal bulb located on a 1999 Pontiac Grand Prix?
There should be a panal inside the trunk if you remove that you can take the nuts off and remove the rear tail light giving you access to the bulb.
How do you replace the rear door lock on 92 Transport?
how do you replace rear door lock assembly on 92 pONTIAC tRANSPORT
How do you replace the rear signal light on a Pontiac Aztek?
open hatchback, take screws out in jam area,,the you can tilt brakelight asembly and pull off,,then change bulb and put abck
How do i Replace the rear turn signal bulb on a 05 beetle?
no no
How do you get the plastic assembly off of the rear end to replace the turn signal bulb?
Rear end of what?
What parts are needed to replace the rear drum brakes on a 1997 Pontiac sunfire?
The only part that is needed to replace your 1997 Pontiac rear brakes is a break assembly kit. The brake assembly kit will have everything you need.
Where is the turn signal on a 2002 Pontiac Sun fire?
We could use a little more info here. The turn signal light? In front? In the rear? The turn signal switch?
How do you replace rear shocks on a Pontiac G6?
The rear shocks on a Pontiac G6 are replaced by supporting the rear axle on jack stands, removing the wheels, and unbolting the shocks. New shocks can then be put in place and bolted on.
