A skimmer weir is the plastic flap and the opening of the skimmer. It traps leaves that are pulled into the skimmer when the pump is running and then holds the leaves in the skimmer whne the pump shuts down
Drain the pool until the water level reaches two inches below the skimmer faceplate , remove the face plate using a screwdriver , remove the faceplate and skimmer , then replace the gasket and attach the skimmer and then the faceplate
Your skimmer door is called a weir. A weir is a pivoting flap, door or dam in a skimmer that keeps bugs and leaves from re-entering a pool or spa by collecting the debris in a basket while letting water recycle through the filter system.
It would be easier to replace with a floating skimmer Check poolrite dragonfly
If this is an above ground pool you could just pull the old skimmer out cut the rusted section of metal out hit it with some rust converter, replace the section where there is no metal with a new metal forget about the old skimmer setup and replace it with a "floating pool skimmer" they do a better job any way.
lift out the skimmer basket there should be a floating diverter with a flap that closes off suction. some skimmer baskets are rotated to do the same thing. insert your hose into the other skimmer. turn off suction to the main drain if you need more suction.
you may have to prime your pump Clean or replace the filter.
Dig it up and replace the leaking section.
www.sunvisordepot.com.they are great!
The heater flap, or blend door, is difficult to replace with OEM parts supplied from Ford. There is an aftermarket kit that makes the job and cost significantly easier at heatertreater.net or on the Ebay listing.
here is how I did it - I built a box out of wood big enough to cover the skimmer area . I built mine out of scrap wood. I then covered the edges of the box with foam window seal to give it a good seal. Place the box over the skimmer area. When you start you will only lose the water inside the box and the water pressure will seal the area. Replace skimmer, remove box.
Yes you can. Drop the waterline in the pool below skimmer level, dig a whole around your skimmer to gain access. Unscrew the skimmer faceplate and remove it as well the old gasket. You also have to remove the second gasket between liner and wall. Detach the pipe(s) from the skimmer. Now install the new skimmer by attaching the pipe(s) to the skimmer put new gaskets in place screw the faceplate back on and you're done. Don't forget to fill your hole again and put water back in the pool to the appropriate level. ;-) Jens Poseidon Pool Services, Dunrobin, ON