Want this question answered?
Deadly, get it carefully to where you can work on it and replace it.
you don't, you have to replace the whole drive shaft.
I got a price from a Ford dealership for 1149$ plus tax. Take your existing drive shaft off and take it to a machine shop and have it re worked its basically the same thing and will only cost you a fraction of the price.
no
what do i have to do to replace the front drive axles on a 2004 ford ecscap???
to replace pinion bearing and seal you need to remove drive shaft.you then remove the pinion nut from pinion shaft. u usually need a pretty good rattle gun to remove this .then remove yoke from front of differential.u may need a puller but usuall tapping with hammer will loosen it. remove the bearing and replace with new one then install seal and replace cover and ypke. replace pinion nut, fill with oil.replace drive shaft
You must remove the rear drive shaft section and then remove the support.
it sounds like a steady bearing on the drive train or pssibly your tourque converter is going bad
how to replace drive belt on a 2005 ford escape XLT 3.0 V-6
Make darn sure it isn't the tire first. Take the strut off, and have the bearing pressed.
Please answer the question Please answer the question
to remove carrier bearing, u will need to removbe the drive shaft from the vehicle the carrier bearing is bolted to chassis with 2 bolts . these will need to be removed and the carrier and bearing will come out with the drive shaft one drive shaft is out you can then knock old bearing and carrier off of shaft with a hammer. the old carrier is no good so doesnt matter if you trash it once you get old one off, carefully known new one onto shaft until seated,being careful to note which is front of carrier bearing you can then reinstall cariier bearing and drive shaft to truck. NOTE: now is a good time to check and replace if needed the U-Joints on the drive shaft