turn the key to the accesories position. pump the break pedal 3 times. the check engin light should flash. then turn the key to the off position and then start the car. the light should reset.
I am not sure if that works I have a 2004 Odysey and I did this and it worked.
While the car is off, push and _hold_ in your Trip meter button, then while still holding that button in... turn your ignition key to _On_ (not start). Wait until light goes out or you need a hair cut... which ever comes 1st. LOL, seriously it should go out in about 15 seconds or less
For a 2007 Honda Odyssey: Turn your ignition to the On position. Press and hold down the trip meter button for ~10 seconds (until the display blinks). Release the trip meter button. Press and hold the trip meter button a second time for ~5 seconds (until the display shows your oil at 100%). Then after all this is done you add oil to the tank and put a lighter in your car seat and wait 15 minutes until you can get back in your car. Then start engine and relax. and remember not to follow any directions after the turn the key part. Thanks.
Not sure what vehicle you have but, the correct procdure would also be found in your drivers manual.
Your owners manual should tell you how to reset the light.
This is basically an "oil change reminder" light. Check your manual on how to reset it.
Normally the light must be reset. The procedure varies from make to make. Your owners manual should tell you how to reset the light.
The oil change light is reset by Key on, engine off. Press the gas pedal to the floor three times. Cycle key off and on.
Reset the change oil light on Mazda 3
how do you reset change the oil light in a 2004 alero?
The Check Engine light has nothing to do with oil changes and if it is on you have an emissions problem. The Maintenance Required light indicates you need an oil change. You must reset that light manually.
hold the buton on the cluster then turn the key to ignition
Depends on the make, model, and year vehicle you failed to list.
== == how do you reset the oil light on a1992 corvette
Disconet the battery for 15 minutes this will reset your oil change light
The oil change light in your car is there to remind you to change your oil in a timely manner. if you do not reset your oil change light, it just wont remind you to change your oil. :)
Your drivers manual should give you the information to reset the oil maintenance light.
i tryed on my car it does not work pit light still on
how to reset engine check light on 2009 murano
With your key in the OFF position, push in and hold the odometer button. Turn the key to the ON position, the odometer will display 000000 after a couple of seconds. at this time, the maintenance light has been reset. This light comes on approximately every 5000 miles to indicate time for an oil change. If you change the oil yourself, just remember to reset the light even if it is not coming on.
It is very easy to reset the oil light after you had an oil change in your 2011 Ford E350. You will just need to disconnect the battery for up to 1 minute to reset the light.
Change your oil/filter and reset the light.
Turn on Ignition - depress gas pedal 3 times
The car actually measures the viscosity of the oil while you are driving and running the car when you change the oil the light will be reset.
how do you reset change oil light on chrysler grand voyager minivan 1997
The quickest way to reset a change oil light on a Durastar 4300 is to change the oil and replace the oil filter. If this is done and the light is still on, disconnect the battery for about 10 minutes and then reconnect it.
A 2001 Intrepid does not have an oil change light.
reset oil chang light of 2006 BMW 750li