Open the hood.
Locate the electrical box next to the battery.
Remove the lid and find the button labeled "oil". It should be red.
Turn on the ignition key but do not start the engine. close the door but leave the window open so you can hear the inside of the car.
Press and hold the red oil button until you hear the door chime, that should take between 5 and 10 seconds.
Verify that the change oil light is out.
I am guessing they mean Oil change reset button. If so. There is a reset button in the fuse box in the engine compartment. Turn your key half way, open the fuse box, press and hold the button for 15 seconds, look at your dash. If the light is flashing you have reset the oil life indicator.
99 percent sure there is NO oil reset procedure for the '97 sc models. If your oil light is on it is bc you are LOW on oil. Add oil immediately
Bottom of the engine on the oil pan.
The oil change light in your car is there to remind you to change your oil in a timely manner. if you do not reset your oil change light, it just wont remind you to change your oil. :)
It means its time to change your oil.After changing your oil.open your hood take the fuse block cover off you will see a red oil reset button push it all the way down and hold for about 5 sec
5qts
how to use bcm to reset change oil light
97 SL2 does not have a change oil light. Only the red oil indicator which means you have a serious problem
When you see the Change Oil light on, push and hold the button just like you would to reset the trip counter
Check the main fuse box. In some of the L series the main fuse box is under the hood, next to the battery.Remove the top of the fuse box and look for the button that says "oil".Turn the key to the "on" position, but don't start the engine.Push and hold the "oil" button until you hear the dashboard chime.Once you hear the chime, you know that the oil light is reset.If your L series Saturn is different, check the owners manual.
From Owners Manual: How to Reset the Oil Life System The GM Oil Life System calculates when to change your engine oil and filter based on vehicle use. Anytime your oil is changed, reset the system so it can calculate when the next oil change is required. If a situation occurs where you change your oil prior to a Change Engine Oil light being turned on, reset the system. After changing the engine oil, reset the system by performing the following steps: 1. Turn the ignition key to RUN with the engine off. 2. Fully press and release the accelerator pedal three times within five seconds. If the Change Engine Oil light is flashing, the system is reset. The light will flash for up to 30 seconds or until the ignition is turned off. If the light comes on again and stays on for 30 seconds at the next ignition cycle, it did not reset. You will need to reset the system again.
check to see if there is a red button in the fuse box next to the battery. if there is push that and it should reset the oil change light.