The AC supply would have to be changed to DC supply.. This would be done with the use of a rectifier. It would be done usually with a full wave rectifier.
Three phase power is almost never supplied to a residence. Power is supplied in two 240-volt lines, referenced to ground, which is also typically wired, giving you three overhead (or underground) lines for supply to a typical residence. A larger apartment building might use three-phase power.AnswerSome countries do indeed supply residences with three-phase supplies instead of single phase. For example, the recently-constructed, two-bedroom, villa in which I live here is Cyprus has a three-phase service and this can be confirmed by examining the three-phase energy meter and the three-phase distribution panel. I don't really know why this should be the case, other than for the purpose of load sharing, as the villa's load is typical of residences elsewhere.
In Europe, low-voltage three-phase distribution is by means of a four-wire system (three line conductors and a neutral) supplied from a wye-connected transformer secondary. In North America, low-voltage is supplied from a delta-connected transformer secondary, one phase of which is centre-tapped and earthed (grounded). The single-phase supply to residences is then supplied by that particular phase, giving 240 V line-to-line and 120 V line-to-neutral. You can tell if you have a delta power when the phase voltage is equal to the line voltage and that you have a star power when the phase voltage =root 3(THE LINE VOLTAGE).
Power can be calculated in each individual phase and summed together. If the voltage is supplied L-N in RMS: P = V*I. Note this will give the same answer as calculating balanced three phase power from the equation P = V*I*sqrt(3)
The power supplied by a three-phase supply, or any supply come to that, is determined by the LOAD, and not by the supply. So you must look at the data provided on the equipment's nameplate to find out what its power rating is.
with 3 phase the rotating field is already set up when power is supplied with single phase you use a capacitor and a second winding to set up the rotating field
With no three phase power supply you can't use a three phase motor of any kind at all!
You need three phase power to get three phase power. If you only have one phase, you will need some kind of inverter or motor-generator set. Generally, however, the demands of a three phase motor will exceed the capability and efficiency of these "tricky" solutions. It is best to simply contact your local power company and have them provide the proper three phase power to your facility.
You will need to determine the power per phase, and add them up to give the total power of the three-phase load. To do this, you will need to multiply the phase-voltage by the phase current by the power factor -for each phase.
Electric power is measured in watts. It does not matter if it is single phase or three phase. All things being equal, for the same load, the power measured in a single phase circuit or a three phase circuit, will be the same.
You don't. A three phase motor will not start unless it is connected to a three phase supply.
Three phase power is always delivering power on one of the phase continuously. This is very useful to manufacturing industries to operate the machines, which require high power utilization.
To use a single/one phase motor instead of a three phase motor is possible if you have a three phase power supply as you will only need to tap one of the three phases together with neutral and an earthwire, however to use a three phase motor instead of a single phase will require the provision of three phase power supply.