answersLogoWhite

0


Best Answer

You must remove the fuel tank in order to access the pump. Once you have the tank out, it is just a matter of removing the pump and installing the new one.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How would you change a 1988 fuel pump on Chevy Corsica?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where are the fuel lines located?

1988 Chevy corsica fuel sending unit whai have a 1988 Chevy corsica i need to no on the fuel sending unit the bib line goes to what line and the two little lines go where please help


Will a 1988 Chevy Corsica 2.8 l engine fit in a 1985 Chevy Celebrity?

I would think that on size alone it would fit and mount in. Depending on which of the engines the 1985 Celebrity had you might need to make a number of modifications to use the Corsica engine in the Celebrity. The two engines are NOT identical.


What else would you replace on a 1988 Chevy Corsica if the car wont start unless you pour gas directly into the carburetor?

fuel pump is the first place i would look


How do you change the ignition switch in a 1988 Chevy Camaro?

How do i change the ignition switch in a 1988 Chevy camaro


Where are the ac service valves on a 1988 Chevy Corsica the 4 cly thank you?

The 1988 Chevy Corsica air conditioning service valves can be found on top of the air conditioning compressor. The air conditioning service valves are labeled as the low pressure valve and the high pressure valve.


How much does a 1988 Chevy Corsica weigh?

The 1988 Corsica made a lot of sales after its debut in 1988. It was an impressive model weighing approximately 2,589-2,688lbs with a standard 2.0 liter four making 90 horsepower and a five-speed manual transmission.


How do you change or fix an ignition switch on a 1988 Corsica when the key turns but does not actuate anything?

If your 1988 Chevy Corsica key only turns in the ignition and does not start the automobile, it is probably unfixable. Remove the ignition switch retaining ring. Slide the out and remove the wiring harness. Reverse the process to install the new ignition switch.


How can you tell which fuse is for what on a 1988 Chevy Corsica?

SIGN UP AT ALLDATA.COM. THEY HAVE ALL YOUR CARS ANSWERS. T HEMPLE


Where is the cam position sensor located on a 1988 Chevy Corsica?

CLICK THE SITE AUTOZONE.COM ON THE RIGHT ---> IT SHOULD HELP YOU


Where is the valve to recharge the air conditioning unit in a 1988 Chevy Corsica?

Low pressure side of compressor (larger hose)


Where is the crank sensor located on a 1988 4 cylinder Chevy Corsica?

It will be on the back side of the engine where the distributor used to be on older engines.


How do you change the ignition control module in a 1988 Chevy Silverado 5.7 L?

How do you change the ignition control module in a 1988 Chevy Silverado 5.7L