answersLogoWhite

0

  • Ford Expedition
  • Ford Expedition Eddie Bauer
  • Ford Expedition XLT

How would you remove the door panel from a 1998 Ford Expedition?


Top Answer
User Avatar
Wiki User
Answered 2011-09-12 20:38:35

Here is how I removed the front passenger side door panel from a 1999 Ford Expedition. The driver's side door should be the same, except for the mirror switch which needs to be unplugged. The 1998 *might* be the same, I don't know, but this should be helpful to someone.

Use a flat blade screwdriver or other suitable tool to pry out on the top of the triangular plastic panel on the top front of the door panel. The plastic holder should pull out of the door. Now pry up on both sides of the triangular panel and pull it loose. Remove the Philips head screw you find under this panel. Pull the door latch handle, pry out the insert where the handle goes through, and remove the bolt that holds the door handle in place. Remove the door handle. Pry up on the ends of the door switch panel to remove it. Unplug the cables by pushing in on the lock tab on the side of the plug and pulling out. Remove the Philips head screw accessible through the switch panel hole. Insert a flat blade screwdriver into the slot at the bottom of the courtesy light lens and pry up and out to remove the lens. Remove the Philips head screw behind this lens. Pull up on the door panel to remove it. Be careful of the courtesy light when removing the panel - give the light a quarter turn counter-clockwise from the rear to remove it from the door panel.

The F-150 appears to be the same as my '99 Expedition - try for some instructions on an F-150, this was helpful for me.

Not a whole lot to improve on this is right on - try visiting Strutmasters.com and see what else we can do for you.

012
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

Instrument panel removal Ford Expedition?

How do you remove the instrument panel in a 1998 Ford Expedition 5.4 Engine


How do you remove drivers side door panel on a 1998 ford expedition?

Door Panels Removal & Installation 1. Remove the sail panel. 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. The installation is the reverse of the removal.


Rear axel removal on 1998 Ford Expedition?

how do you remove the right rear axle on a 1998 ford expedition?


How do you install a mirror on the front passenger door on a 1998 Ford Expedition?

Door Panels Removal & Installation 1. Remove the sail panel. 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. The installation is the reverse of the removal.


How do you remove the inside handle off a 1998 civic?

Remove the door panel


How do you remove the rear passenger door panel on a 1998 Expedition?

THere is two screws on the bottom of panel. then there is a plate behind door latch remove and there is a screw 5/16 or 8mm will do it then unplug window module then lift up. Yeah I got it. Kenny Wideman Jersey_bad_boy@yahoo.com


How to replace a power window switch 5-button 1998 Dodge Intrepid?

There are 10 Phillips screws holding the door panel on. First you would need to remove those. Then you can remove the door panel from the door. On the backside of the door panel you would need to remove the plugs from the backside of the switches. Then you can remove the screws that hold the switch into place on the door panel.


What is the fuse panel layout for 1998 Ford Expedition?

fuse panel schedule 1998 Ford Expedition fuse panels diagram and location ------------------------------------------------------------------------------------------------- You can view the 1998 Ford Expedition owners manual online at : www . motorcraft service . com ( no spaces ) Click on Owner Guides ( the fuses and relays section starts on page 128 ) Helpfull


Where is fuse panel in 1998 expedition?

According to the 1998 Ford Expedition Owner Guide : The fuse panel is below and to the left of the steering wheel , by the brake pedal Also , the Power Distribution Box ( which is " live " ) is located in the engine compartment , on the drivers side of the engine compartment


How Can you change The passenger side view mirror on a 1998 Ford Expedition?

Door Panels Removal & Installation 1. Remove the sail panel. 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. (Change the passenger side view mirror) 4. The installation is the reverse of the removal.


Where would the Fuel Pump Inertia Switch be on a ford expedition 1998?

In the right front passenger footwell , behind the kick panel ( according to the owners manual )


How do you take off the front panel around the radio on a 1998 Ford Expedition?

Just completely removed the dash. The panel around the radio on my 1999 Expedition just popped out with my fingernails. No screws. Hope this helps.


Where is the ABS speed sensor in a 1998 expedition?

if your looking for the front abs sensors thay are located in the hubs, and would have to remove front tire, brakes,caliper, and rotor to remove.


Remove door panel on 1998 Ford Ranger?

The 1998 Ford Ranger door panel has eight retaining clips. Pry outward on each retaining clip. Remove the two door handle screws.


How do you get the door panels off of a 1998 expedition xlt to change the speakers?

Replacement of your speakers, you will have to remove door panel. To remove the door panel, you have to pry off the top triangle trim, remove the screw behind it, remove the panel holding the door lock/window switches, remove the screw behind there, push straight up from the bottom and pull out at the same time. The clips holing it are at a right angle facing downward and you need to lift up about 3/4 of an inch then pull out.


How do you remove rear speaker covers on a 1998 Ford Expedition?

If your talking about the door speakers then you will have to remove the door panels to get to the speakers.


How do you replace the dash speakers in a 1998 Chrysler Cirrus?

Remove center stack bezel (radio, heater control), remove screws from instrument trim panel at ctr stack and remove instrument trim panel, remove dash top panel, replace speakers.


Door panel removal on 1998 firebird?

remove black plastic panel on inside behind mirror. remove switch panel by pushing forward then lifting up. disconnect wiring. remove panel covering door handle[one screw]. remove screw behind this panel. remove screw at top of arm rest from underneath rest. remove screw from underneath back corner of armrest.now lift straight up on door panel.


How do you replace the driver side view mirror on a 1998 ford expedition?

Remove the front door sail panel. There you will see 3 bolts holding the side view mirror. Remove bolts, replace / or fix side view mirror. Installation is the reverse of removal.


Where is the reset for the fuel switch on the 1998 Ford Expedition?

?? BUT 1999 is at front passengers floor board right panel I think.


Where is the fuel shut off switch in a 1998 ford expedition?

In the right front passenger footwell , behind ( or by ) the kick panel


How do you replace Side mirror on a 1998 sls cadillac?

remove the door panel screws and pull up on the door panel to correctly remove it. then remove the 3 bolts on the upper corner and unplug and replace


How do you remove the door panel of 1998 Toyota Tacoma?

Call an Auto body guy


Where is the flasher relay fuse located on a 1998 ford expedition?

In the fuse panel located below and to the left of the steering wheel by the brake pedal , in location # 1 - 15 amp - flasher relay ( according to the 1998 Expedition owners manual )


How do you remove a 2003 ford expedition door panel?

If its the same as a 2000 expedition Here is how I removed the front passenger side door panel from a 1999 Ford Expedition. The driver's side door should be the same, except for the mirror switch which needs to be unplugged. The 1998 *might* be the same, I don't know, but this should be helpful to someone. Use a flat blade screwdriver or other suitable tool to pry out on the top of the triangular plastic panel on the top front of the door panel. The plastic holder should pull out of the door. Now pry up on both sides of the triangular panel and pull it loose. Remove the Philips head screw you find under this panel. Pull the door latch handle, pry out the insert where the handle goes through, and remove the bolt that holds the door handle in place. Remove the door handle. Pry up on the ends of the door switch panel to remove it. Unplug the cables by pushing in on the lock tab on the side of the plug and pulling out. Remove the Philips head screw accessible through the switch panel hole. Insert a flat blade screwdriver into the slot at the bottom of the courtesy light lens and pry up and out to remove the lens. Remove the Philips head screw behind this lens. Pull up on the door panel to remove it. Be careful of the courtesy light when removing the panel - give the light a quarter turn counter-clockwise from the rear to remove it from the door panel.