Brake Pads and Rotors
Grand Am SE
Chevy El Camino

How would you replace the brakes on your 1985 El Camino or how much would it cost to get it done?

464748

Top Answer
User Avatar
Wiki User
2005-10-09 19:08:37
2005-10-09 19:08:37

autozone.com check out this site,type in you're vehicle info and follow the instuctions. good luck.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

3400 lbs is what a normal El-Camino weights

User Avatar

what is the bolt pattern for 1985 el camino

User Avatar

depending on condtion. in good maybe $2100

User Avatar

There were 3 factory installed engines in a 1985 El Camino - the 4.3L V6, the 5.0L V8 or the 5.7L diesel V8.

User Avatar

The 1985 Chevrolet El Camino dipstick length is 27 inches. The dipstick needs to be exact in order to measure the oil properly.

User Avatar

if it has the LG4 then it is rated at 160hp

User Avatar

inside the left front fender

User Avatar

I would say no more than 2,000lbs. Trailer brakes would be helpful.

User Avatar

The fuse panel on an El Camino of that style is located under the dash, where the driver's left leg would be. There is a square cutout in the under dash panel where it is located. You will have to lean under the dash to see it.

User Avatar

The 1985 Chevrolet El Camino ignition switch can be removed by loosening the retaining ring at the top of the switch. The switch will slide out. Remove the wiring harness from the back of the ignition switch.

User Avatar

you need to take off the master cylinder and the accumulator and replace it with a master cylinder from a non antilock vehicle like a thunderbird or cougar from about 1985 to 1988.

User Avatar

The 1985 Toyota Tercel brakes are equipped with an adjustment bolt. Turn the adjustment bolt to raise or lower the brake shoe.

User Avatar

replace ighnition switch for 1985 chevlot

User Avatar

Should be located in or near the fuse box - just unplug or in my case (85 el camino)there are two flashers behind the brake release under the dash,not down by the fuse box. (87) El Camino same place. Had to remove 6 screws to get to it. Look left and up (back towards driver) should be standard 12v flasher for both.

User Avatar

How do you replace a 1985 Hyundai Elantra Front Axel

User Avatar

The headlights do not have a fuse. There is a circuit breaker built into the headlight switch.

User Avatar

21,816 el caminos and 2,503 GMC sprint/caballeros

User Avatar

how do you replace a fuel filter on a 1985 G.M.C. High Sierra

User Avatar

how do you replace a wheel bearing on an 1985 oldsmobile regency 98

User Avatar

On the 4WD SR5 truck, front brakes are disc, and rear brakes are drum.

User Avatar

if it came stock with the 305 it should bolt right up, but im no expert Z-44) yes i have a 1985 el camino that originally had a 305 and swapped it for a 350 pretty easily. you can actually fit a 383 with minor changes (different motor mounts etc.)

User Avatar

well in a sence it dose because all 4 brakes lock when you stop, but then it dose not because only the front brakes stop


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.