Home
Wiki User
Answered 2008-02-14 19:06:09
Listed in detail in your owner's manual. Don't have one then you need to get one.
Your Answer
Related Questions
With engine off. Turn key to on. Press accelerator fully three times. This should reset light.
Use an OBD scan tool to reset or disconnect the battery
go to auto zone they will do it for you
The ABS light is on because there is a problem with the system. Until the problem is fixed the light will remain on. Once the problem is fixed the light will reset itself.
The abs light is on because you have a problem with the abs system. The light will remain on until the problem is fixed. Once the problem is fixed the light will reset itself.
You should be able to reset the low coolant light by the parking light switch 3 times on and off somewhat quickly should do it
There is not a reset switch.
See How to Reset the Change Engine Oil Message on page 6-18 of your "Owner's Manual", under Section 6: Service and Appearance Care - Engine Oil...
turn the parking lights on and off 3 times
disconnect your battery and then reconnect. The light should reset and turn off.
Turn on the ignition but do not start the engine. Depress the accelerator to the floor 3 times within 5 seconds. The oil light should blink and then go out.jd
Take it to your Dealer for repairs. It could be any number of sensors or the contacts in the column.
Just disconnect the negative cable from your battery for a good ten to fifteen minutes so that the main does itself a reset.
most GM vehicles you turn the key to the on position (don't start) and depress the gas pedal 3 times within 5 seconds.
Chevrolet does not use inertia/reset switches.
This light has to be reset by the person doing the oil change. It is not automatic when the oil is changed.
Turn the key to the on posistion. (Do not start the car). Press the gas pedal 3 times slowly and it should reset the light. I used to be able to reset it through the radio but I dont have the original one that came with the car.
There is not a reset switch.
There is nothing to reset except the radio presets and the clock.
Either try disconnecting thebattery for about 10 mins. or have vehicle scanned to determine the problem
How do I reset the service engine light on a 2003 Chevy Trailblazer?
The easiest way to reset the ABS light in a 1992 Chevy Lumina is to disconnect the battery for about 30 minutes. When it is reconnected, the light should be reset.
Disconnect the neg battery cable for 10 mins.
How do you reset check engine light for the 2009 Chevy trail blazer?
This is how to reset the "CHANGE OIL" light for a 96 Impala SS: 1. Turn the key to the "RUN" position with the engine OFF. 2. Push and release the gas pedal three times within five seconds. 3. Wait for the "CHANGE OIL" light to flash two times as a confirmation that the system has been successfully rest. If the "CHANGE OIL" light comes on and stays lit for five seconds, the system has NOT been reset. Therefore, you must repeat steps 1 & 2.
If you are 13 years old when were you born?
Asked By Wiki User
What is the fourth element of the periodic table of elements?
Asked By Wiki User
How would you reset the oil change light in a 2003 Chevy impala?
Asked By Wiki User
Is Duranice Pace husband dead?
Asked By Wiki User
How old is wes mccoy from shopnbc?
Asked By Wiki User
What is Hugh hefner penis size?
Asked By Wiki User
What classification instrument of tongatong?
Asked By Wiki User
